User's Manual

WST-401 Wireless Tilt Sensor

Specifications

Frequency: 319.5MHz Operating Temperature: -22° to 120°F (-30°to 49°C)

Battery: One 3Vdc lithium CR123A (1550 mAh) Operating Humidity: 5-95% RH non condensing

Battery life: 5-8 years Compatible with GE/Interlogix receivers

Tilt Sensor Supervisory signal interval: 60 min (approx.)

Enrolling

To enroll the sensor, set your panel into program mode, then go to the Learn Sensors menu. Refer

to your specific alarm panel manual for details on these menus. To activate the case tamper

simply slide the cover up and down, you will hear a click when the case latches are engaging and

disengaging. Continue until the panel responds to the sensor. Then select the appropriate sensor

group and number.

Tilt Sensitivity

The tilt sensor will activate when the device is approximately at a 45 degree angle. By moving the

actual ball sensor up or down you can adjust this angle by a few degrees.

Note that this device has a delay of approximately 1 second to eliminate false alarms cause by

wind and vibration commonly subjected to a large garage door.

Mounting

Included with this device are mounting screws and double sided tape. For reliable bonding with

the tape ensure the surface is clean and dry. Apply the tape to the sensor and then to the desired

location. Apply firm pressure for several seconds. It is not recommended to mount the tape at

temperatures below 50°F, although after 24 hours the bond will hold at low temperatures.

Replacing the Battery

When the battery is low a signal will be sent to the control panel. To replace the battery:

1. Remove the screw securing the top cover, then remove the top cover to reveal the battery.

2. Replace with a CR123A battery ensuring the + side of the battery faces as indicated on the

device.

3. Re-attached the cover and replace the screw to secure the cover.

PAGE 1
WST-401 Wireless Tilt Sensor Specifications Frequency: 319.5MHz Battery: One 3Vdc lithium CR123A (1550 mAh) Battery life: 5-8 years Tilt Sensor Operating Temperature: -22° to 120°F (-30°to 49°C) Operating Humidity: 5-95% RH non condensing Compatible with GE/Interlogix receivers Supervisory signal interval: 60 min (approx.) Enrolling To enroll the sensor, set your panel into program mode, then go to the Learn Sensors menu. Refer to your specific alarm panel manual for details on these menus.
PAGE 2
FCC Compliance Statement This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC Rules. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.