User's Manual

Automatically Connecting to a Network
1.
If one or more broadcast networks are present, the Network
Indicator icon ( ) appears in the Navigation bar. Tap the
network you want to connect to, and then tap whether the
network connects to the Internet (does not use proxy settings) or
Work (uses proxy settings).
2.
If you are prompted for a Network Key (WEP), enter it and tap
Connect. If you are not sure, contact your network
administrator.
CAUTION: A new network that does not request an encryption key may not be a
secure network. To check whether an existing network uses encryption, check the
Encryption Status of the network. Tap Start > i.roc x20 Wireless > Wi-Fi icon >
Manager button. Refer to
“Monitoring Signal Strength and Status” later in this chapter
for more information.
Manually Entering New Network Settings
A wireless network can be added either when the network is detected
(the Network Indicator icon is showing in the Navigation bar) or
manually by entering setting information. To manually add a wireless
network:
1.
Be sure Wi-Fi is powered on.
2.
Tap the Connections icon ( or )> Settings >
Advanced tab > Select Networks button.
3.
Enter or select the network name (or tap New) you want to use
to either connect to the Internet using an ISP or a Virtual Private
Network (VPN) for work. Tap OK once completed.
4.
Set up your Dialing Rules and Exceptions and press OK.
The next step is to setup your network interface cards.
5.
From the i.roc x20 Wireless screen, tap > Settings.
6.
Select Add New... in the list box on the General tab to start
configuring wireless networks.