User's Manual

Datum // date
15.03.2013
Teile-Nr. // part no.
300011
Dokument-Nr. Revision //
document no. revision
300011AL11E 04
Head Module Settings
User Manual
Seite/gesamt // page/total
2 / 8
Dokument erstellt // document created
SAS387 15.03.2013
Dokument geprüft // document checked
FIH091 ,09.04.2013
User Manual: Head Module Settings ● Ablageort: I:\300011\083_Software\05 Dokumente\300011AL11E04_user_manual_head_module_settings.docx ● template no.: 0730QV06A03 ● template created: HAO006 20.01.2011 ● template checked: BEA373 20.01.2011 ● location: ISO drive ●
ecom instruments GmbH
1 Head Module Settings
1.1 Introduction
The Head Module Settings are there for controlling the head modules. They provide the following: enable
or disable a head module (see 1.2 Enable Module) set settings for each head module (see 1.3 #L|F –
TLB30, 1.4 #H – UNI13, 1.5 #Q – ARE8 1.6 #T – LID and 1.7 S# - SE955), set a preamble/postamble for
the output data (see 1.8 Wedge Data), enable or disable the beep that should be ringing out or not after
a good read (see 1.9 Good Read), display version of the service of the head modules which is installed
on your device (see 1.10 Version Info). The Head Module Settings are located in the Intermec Settings.
To open the Head Module Settings click on the windows icon on the main screen. Then click on Settings
->System->Intermec Settings (see Step1-3). Scroll down until “Head Module Settings” (see Step4) and
click on it. The Head Module Settings will be opened. After you have made any settings in the Head
Module Settings you can start reading with your head module by clicking the blue center button on the
keyboard of your device.
Step1 Step2
Step3 Step4