Parts List/Tune Up Info

ManualsBrandsecom ManualsCell PhonesFeaturephone

Tune-up procedure

Each device is individually calibrated during manufacturing. Measurement is

performed in a full calibrated setup using Wideband Radio Communication

Tester or spectrum analyzer and power meter.

Measurement procedure is outlined below:

1. Set the device to operational voltage and on a predefined band class and

channel.

2. The maximum output power is measured when the power control bit is set

as all UP bits. The WWAN RF output power will be adjusted equal or lower

than tested power shown in the test report.

3. The WIFI specific RF characteristics were measured by spectrum analyzer

and power meter.

The user has no possibility to change these settings.

Tune up procedure shall be over the power range or at specific operating

power levels.

1. It must provide an operational voltage to turn on the device and on one

certain channel in service mode by means of company proprietary

software.

2. The Base station simulator measures the WWAN device specific RF

characteristics.

3. The maximum gains of each individual device are adjusted until the target

value met.

Summary of content (6 pages)

PAGE 1
Tune-up procedure Each device is individually calibrated during manufacturing. Measurement is performed in a full calibrated setup using Wideband Radio Communication Tester or spectrum analyzer and power meter. Measurement procedure is outlined below: 1. Set the device to operational voltage and on a predefined band class and channel. 2. The maximum output power is measured when the power control bit is set as all UP bits.
PAGE 2
Conducted Power Table GSM Band Band GSM 850 GSM 1900 Mode Target Power (dBm) Tolerance (dB) GSM (GMSK, 1Tx-slot) 32.50 (-1.5,+0.5) GPRS (GMSK, 1Tx-slot) 32.50 (-1.5,+0.5) GPRS (GMSK, 2Tx-slot) 32.00 (-1.5,+0.5) GPRS (GMSK, 3Tx-slot) 31.50 (-1.5,+0.5) GPRS (GMSK, 4Tx-slot) 31.00 (-1.5,+0.5) EDGE (8PSK, 1Tx-slot) 28.00 (-1.5,+0.5) EDGE (8PSK, 2Tx-slot) 27.50 (-1.5,+0.5) EDGE (8PSK, 3Tx-slot) 27.00 (-1.5,+0.5) EDGE (8PSK, 4Tx-slot) 26.50 (-1.5,+0.5) GSM (GMSK, 1Tx-slot) 30.
PAGE 3
WCDMA Band Band WCDMA II WCDMA IV Mode Target Power (dBm) Tolerance (dB) RMC 12.2K 24.00 (-1.5,+0.5) HSDPA Subtest-1 24.00 (-1.5,+0.5) HSDPA Subtest-2 24.00 (-1.5,+0.5) HSDPA Subtest-3 24.00 (-1.5,+0.5) HSDPA Subtest-4 24.00 (-1.5,+0.5) HSUPA Subtest-1 24.00 (-1.5,+0.5) HSUPA Subtest-2 24.00 (-1.5,+0.5) HSUPA Subtest-3 24.00 (-1.5,+0.5) HSUPA Subtest-4 24.00 (-1.5,+0.5) HSUPA Subtest-5 24.00 (-1.5,+0.5) DC- HSDPA Subtest-1 24.00 (-1.5,+0.5) DC- HSDPA Subtest-2 24.
PAGE 4
WCDMA V RMC 12.2K 24.00 (-1.5,+0.5) HSDPA Subtest-1 24.00 (-1.5,+0.5) HSDPA Subtest-2 24.00 (-1.5,+0.5) HSDPA Subtest-3 24.00 (-1.5,+0.5) HSDPA Subtest-4 24.00 (-1.5,+0.5) HSUPA Subtest-1 24.00 (-1.5,+0.5) HSUPA Subtest-2 24.00 (-1.5,+0.5) HSUPA Subtest-3 24.00 (-1.5,+0.5) HSUPA Subtest-4 24.00 (-1.5,+0.5) HSUPA Subtest-5 24.00 (-1.5,+0.5) DC- HSDPA Subtest-1 24.00 (-1.5,+0.5) DC- HSDPA Subtest-2 24.00 (-1.5,+0.5) DC- HSDPA Subtest-3 24.00 (-1.5,+0.
PAGE 5
LTE Band Band Mode Target Power (dBm) Tolerance (dB) LTE 2 QPSK/16QAM 22.50 (-1.5,+0.5) LTE 4 QPSK/16QAM 22.50 (-1.5,+0.5) LTE 5 QPSK/16QAM 22.50 (-1.5,+0.5) LTE 7 QPSK/16QAM 22.50 (-1.5,+0.5) LTE 12 QPSK/16QAM 22.50 (-1.5,+0.5) LTE 13 QPSK/16QAM 22.50 (-1.5,+0.5) LTE 25 QPSK/16QAM 23.00 (-1.5,+0.5) LTE 26 QPSK/16QAM 23.00 (-1.5,+0.5) LTE 41 QPSK/16QAM 24.00 (-1.5,+0.5) LTE 66 QPSK/16QAM 23.00 (-1.5,+0.5) LTE 71 QPSK/16QAM 23.00 (-1.5,+0.
PAGE 6
BT Band BT Mode Target Power (dBm) Tolerance (dB) GFSK 9.00 (-1.5,+0.5) π/4-DQPSK 7.00 (-1.5,+0.5) 8-DPSK 7.00 (-1.5,+0.5) LE -0.50 (-1.5,+0.5) LTE Maximum Power Reduction (MPR) for Power Class 3 Modulation Channel bandwidth / Transmission bandwidth 3GPP configuration [RB] 36.101 MPR setting (dB) 1.4 3.