Ex-Handy 07 Safety instructions
Contents 1. Application ...................................................................................................................... 11 2. Safety precautions ....................................................................................................... 11 3. Faults and damage........................................................................................................ 11 4. Safety regulations .......................................................................................
1. Application 1.1 ATEX & IECEx The Ex-Handy 07 is an intrinsically safe water-, dust- and impact resistant mobile phone for industrial application in areas with an increased risk of explosion in zone 1, zone 2, zone 21 and zone 22 in accordance with directives 1999/92/EC (ATEX 137), 94/9/EC (ATEX 95) and the IECEx System. 1.2 NEC & CEC The Ex-Handy 07 is an intrinsically safe water-, dust- and impact resistant mobile phone for industrial application in areas with an increased risk of explosion.
. Safety regulations Use of the Ex-Handy 07 intrinsically safe mobile phone assumes that the operator observes the conventional safety regulations and has read the certificate of conformity in order to eliminate faulty operation of the device. The following points are to be observed: - The device has to be protected against strong impacts. - The device must be protected against permanent UV-radiation. - The unit should not be used in close proximity to processes generating high charges.
Approved for zone 1 and 2, device group II, explosion group IIC (explosive gases, vapors or mist), temperature class T4. Approved for zone 21 and 22, device group III, explosion group IIIB (combustible flying, non-conductive dust), maximum Temperature 130°C. 5.2 IECEx IECEx Certificate of Conformity no.: IECEx EPS 11.0005 X Ex-Marking: Ex ib IIC T4 Gb IP54 Ex ib IIIB T130°C Db IP5X Ambient temperature: Ta -20 °C ...
7. Changing the battery Changing the battery is allowed only outside hazardous areas! Please also observe 4 Safety regulations. 1. If the battery is mounted, switch off the phone and turn the battery module’s screws anti-clockwise with a suitable screwdriver. 2. Lift the battery module at the top side between the screws. 3. Insert your SIM and – if needed – a MicroSD card (max. 16 GB). 4.
- If the battery is completely discharged, the phone will not switch on and the display will not show a charging process. Connect the phone to the charger. After charging for a few minutes the display will appear again and you can then switch on the phone. 8. Safety precautions for the battery Damaged batteries and chargers should be removed from use and sent to ecom instruments GmbH for inspection. Note: - Extreme temperatures can have an adverse effect on charging the battery module.
9. Repair Repairs are to be conducted by ecom instruments GmbH or by personnel or service centers authorized by ecom instruments GmbH, because the safety of the device needs to be tested after repairs are implemented. The actual repair report sheet can be downloaded from the service area at www.ecom-ex.com. 10. Cleaning, maintenance and storage - Only use a suitable cloth or sponge to clean the phone. Do not use any solvents or abrasive cleaning agents when cleaning.
Note: The battery used in this unit poses a fire hazard and can cause chemical injuries if it is used improperly. Neither the battery nor the battery cells should be opened or disassembled and they should not be burned or exposed to temperatures exceeding 100 °C. If the battery needs to be disposed of, it can be removed as described under point (8.1). The disposal regulations specified above are also applicable for old devices. All batteries and rechargeable batteries can be recycled.
If the limitation of a legal warranty as well as the exclusion or limitation of accompanying or consequential damage is not permissible in certain countries, it may be that the aforementioned limitations and exclusions are not valid for every purchaser.
Copyright© 2011 ecom instruments GmbH. Der Inhalt dieses Dokuments darf ohne vorherige schriftliche Genehmigung durch die ecom instruments GmbH in keiner Form, weder ganz noch teilweise vervielfältigt, weitergegeben, verbreitet oder gespeichert werden. Der Inhalt dieses Dokuments wird so präsentiert, wie er aktuell vorliegt.
