Operation Manual

Advanced Menu

The Advanced menu contains the advanced settings as shown next.

Main

Advanced

Security

Boot

Exit

SATA Mode Selection:

Digitizer Type:

Serial port COM1:

Serial port COM2:

Serial port COM4:

Boot-time Diagnostic Screen:

[AHCI]

[AIP1040]

[Enabled]

[Disabled]

Item Specific Help

Determines how SATA

controller(s) operate.

NOTE: Turbo memory

function need to enable

SATA AHCI mode. If not

Turbo memory does NOT

have function.

F1 Help ↑↓ Select Item -/+ Change Values F9 Setup Defaults

Esc Exit ←→ Select Menu Enter Select  Sub-Menu F10 Save and Exit

SATA Mode Selection sets the mode to enhanced

AHCI

(Advanced Host

Controller Interface) or

IDE

. Turbo memory feature works only when the

SATA AHCI mode is enabled.

Digitizer Type or TouchScreen (actual item shown depends on your model)

Digitizer Type allows you to select the type of digitizer you are using.

TouchScreen allows you to unconditionally disable it when set at

Disabled

Serial Port COM1/COM2/COM4 allows you to unconditionally disable it

when set at

Disabled

Boot-time Diagnostic Screen allows you to display the diagnostic screen

during system boot-up.

AHCI