Use and Care Manual

ENGLISH
Keep original carton for storage of the fan. Coil and tie the power cord to avoid damage during storage.
REPAIR:
WARNING: DO NOT OPERATE THE FAN WITHOUT THE GRILLE IN PLACE. DO NOT USE THE FAN
IF IT HAS MALFUNCTIONED OR BECOME DAMAGED IN ANY WAY.
STORAGE:
This warranty covers any defects in materials or workmanship of the enclosed product.
Alton Industry Ltd. Group will repair or replace any defective materials due to craftsmanship of
the product. This warranty does not cover any problem caused by misuse, abuse, accidents or
acts of God, such as floods or hurricanes. Consequential and incidental damages are not
covered under this warranty. Coverage terminates if you sell or otherwise transfer the
ownership. If you feel you have a defective product, please submit a copy of your receipt to
the address below and call 1-888-899-0146 for instructions prior returning this itemto the store
or sending back to:
Alton Industry Ltd. Group
643 Innovation Drive West Chicago, IL 60185
We will inspect the product and contact you within 72 hours to give you the results of our
inspection. We reserve the right to repair or replace the product at our discretion. However, we
may replace the product with one of similar but not exact features. Parts and Service Information
available call Alton Industry at 1-888-899-0146 This warranty gives you specific legal rights.
You may have other rights which vary from state to state.
SAVE YOUR RECEIPTS
THIS WARRANTY IS VOID WITHOUT THEM
2-YEAR LIMITED WARRANTY
WARRANTY
TROUBLESHOOTING
WARNING:
TO REDUCE THE RISK OF INJURY FROM MOVING PARTS AND/OR ELECTRIC SHOCK, TURN
POWER SWITCH OFF AND DISCONNECT GROUNDED PLUG FROM ELECTRICAL OUTLET BEFORE
PERFORMING TROUBLESHOOTING CHECKS.
Minor problems often can be fixed without calling customer service.
The motor does
not run.
Unit runs but
the fan makes loud
scraping noise.
Unit runs but
vibrates
excessively.
PROBLEM CAUSE SOLUTION
1. Plug unit in.
2. Place in "ON" position.
Unit is not
rotating.
1. No power to unit.
2. Switch not on.
1. Obstructions are keeping the fan
from working.
1. Unit has been severely jolted
causing fan blade to rub against
housing or housing to deform.
1. Dirt build up on fan blade.
2. Severe jolt has bent motor
shaft.
1. Contact customer service.
1. Contact customer service.
1. Check for obstructions. If you turn the fan off.
Unplug the fan and carefully remove the obstruction.
Plug the fan in and turn it on again by referring to
the operating instructions.
7