Specifications

• 4 • Application Guide • BALTIC - 0108
EASY TO INSTALL AND SERVICE
PLUG and PLAY Unit
All options are factory installed on the unit, which means that they
are ready for use on installation, ensuring that the time spent
on site is minimised, reducing the installation effort, which can
result in cost savings.
Bottomentry(throughthebase)forelectricalpowerandHot
Water(ifoptiontted)linesareavailableasstandard.
To makeinstallation easier, Lennox have modied the Baltic
power supply. It is not required anymore to have "neutral" hooked
up to the unit (with the only exception of the extract fan option
whichrequiresNeutral).
Baltic should be powered by 400 V, 3phases, 50 Hz.
Circuit breakers
To improve the safety of the BALTIC and extend its life, circuit
breakers protect against over-loading, over intensity and a
disconnected supply phase. Maintenance is also improved as
there is no requirement to change fuses. The electrical panel is
manufacturedinaccordancewithEN60204-1(1998)electrical
directive.
Numbered wires
All wires and connectors are numbered as shown on the electri-
cal drawing to facilitate maintenance and diagnostic.
GENERAL DESCRIPTION
Handling
To facilitate handling and to minimise the risk of damage to the
units from site lifting and positioning, LENNOX has equipped
the BATLIC range with "retractable lifting lugs" at the bottom
of the unit.
During transportation, when minimum footprint is required, the 4
"retractable lifting lug", will be folded in the chassis. They can be
unfolded for lifting, putting all the lifting equipement away from
the casing, therefore reducing risk of damaging the casing.
For the same reason, the condenser coils are protected with an
"Aquilux" sheet, guarding them against damages that sometimes
occur in transit.