Instructions / Assembly

4
Parts of the System
Filtered Water
Faucet
SINK
Water Supply
Fitting
HOT
COLD
Shutoff Valve
Yellow Tubing
WATER IN
Blue Tubing
WATER OUT
Install the mounting hardware at
least
15-1/2” above the bottom
of the cabinet, to provide a mini-
mum of 1-1/2" under the system
for removing the filter cartridges
to change them.
8-1/2”
Filter
1
Filter
2
Filter
3
FIG. 2
= F
ilter system assembly
= Water supply fitting
= F
iltered water faucet for sink or countertop mounting
= C
olor coded 3/8" tubing to make all needed connections
Materials and Tools Needed
NOTE: Gather the required tools before starting installation. Read and
follow the instructions provided with any tools listed here.
= Slotted and Phillips screwdrivers
= Pliers and adjustable jaw wrench
= Tubing cutter
= Electric drill and 1-1/4" drill bit if mounting hole is needed for the faucet
IMPORTANT: To avoid damaging the sink, consult a qualified plumber or
installer for drilling procedures in porcelain or stainless steel.
Typical Undersink Installation
Plan to install the water filtration system near the cold water supply pipe, under the kitchen and/or bath-
room sink, to filter the cold drinking water. Refer to the following drawing.