Instructions / Assembly

ManualsBrandsEcoPure ManualsKitchenReplacement Filter Pack for Reverse Osmosis Water Filtration System

Step A - Install Supply Water Fitting

heck and comply with local plumbing codes as you plan,

then install a cold feed (supply) water fitting. Refer to the

pecifications page for supply water requirements. The fit-

ting must provide a leak-tight connection to the RO 1/4" tub-

ing. A typical connection using the included water supply fit-

ting is shown in Figure 7.

NOTE: Local code may dictate which type of water fit-

ting is used. Consult a plumber if you are not familiar

with local codes or plumbing procedures.

NOTE: Codes in the state of Massachusetts require

installation by a licensed plumber and do not permit

the use of saddle valves.

If you live in the state of Massachusetts, review plumb-

ing code 248-CMR of the Commonwealth of

Massachusetts before proceeding with the installation.

INSTALL COLD WATER SUPPLY FITTING

(Included)

This fitting will be installed on the cold water pipe. The fit-

ting must provide a leak-tight connection to the Reverse

Osmosis 1/4" tubing. Locate the cold water line in the sink

cabinet. It is recommended, but not required, that the cold

water line be soft water.

Complete the following steps to install the water supply fit-

ting.

1. Close the water shutoff valve (angle stop valve) that the

water supply fitting will be installed on, and open

faucet(s) to relieve pressure.

2. Disconnect the existing cold water line from the water

shutoff valve.

3. Make sure that the water supply fitting’s gasket is inside

the female threaded portion of the fitting.

4. Install the water supply fitting onto the cold water shutoff

valve, where the existing cold water line was removed,

and hand tighten. Be careful not to cross thread or over-

tighten.

5. Connect the existing cold water line to the male threaded

portion of the water supply fitting and hand tighten. Be

careful not to cross thread or overtighten.

Cold Water Supply Connection

(included in package)

1/4” green

tubing to

Reverse

Osmosis inlet

FIG. 7

Cold Water

Shutoff Valve

cold water

shutoff

cold water

line

water supply

fitting

gasket