Use and Care Manual
Performance Data Sheet
Model EPPRF30 Universal Pitcher Filter
IMPORTANT NOTICE: Read this Performance Data Sheet and compare the capabilities of this
unit with your actual water treatment needs. It is recommended that, before purchasing a
water treatment unit, you have your water supply tested to determine your actual water
treatment needs. This filter system is designed to be used for the reduction of the
performance claims listed below. Do not use where water is microbiologically unsafe or of
unknown quality, without adequate disinfection before or after the system. While testing was
performed under standard laboratory conditions, actual performance of the system may vary based on local water conditions. S ome or all of the
contaminants reduced by this unit may not be in your water supply.
Performance Claims
Required NSF Max. Average Avg. / Max.
Influent Permissi ble Influent Effluent Avg. / Min. EPA
1
Level Eff. Level Level Level Percent MCL
(mg/L)
2
(mg/L)
2
(mg/L)
2
(mg/L)
2
Removal (mg/L)
2
Substance
Chlorine Taste, and Odor 2.0 10% 50%
3
2.0 0.07 /0.08 96.5/86.6 None
6
Particulate, Class II (>0.5 to <5 micron)10,000
4
85%
3
490,000
4
4000/7800
4
99.3/96.5 None
4
1
EPA MCL means Environmental Protection Agency Maximum Contaminant Level as requi red under the Safe Drinking Water Act.
2
mg/L means Milligrams Per Liter, which is equivalent to parts per million (PPM).
3
NSF minimum percent reduction requirement. Acceptance level for this substance is based on percent reduction rather than maxi mum effluent concentration.
4
#/mL means particles per milliliter.
General Information
This filter improves the taste and odor and reduces particulates in drinking
water.
This system has been tested according to NSF/ANSI 42 for the reduction of the
substances listed. The concentration of the indicated substances in water
entering the system was reduced to a concentration less than or equal to the
permissible limit for water leaving the system, as specified in NSF/ANSI 42.
The testing was performed using spiked tap water at a flow rate of 2 GPD (7.6
L/min.), pH of 7.5 0.5, and temperature of 68 5F.
Manufactured and warranted by:
Ecodyne Water Systems
1890 Woodlane Dri ve
Woodbury, MN 55125
201-8401316
Instal lation Requirements
Service Life .......................................................... 40 Gallons (151 Liters)
Maintenance
Filters should be replaced every 40 gallons or 2 months, whichever comes first.
For replacement filters, visit ecopure.com or call 1-800-693-1138. Replacement
filter prices will vary. Current pricing replacement filters EPPRF30
approximately $10.00 to $20.00 per filter element.
Filter Tested and Certified by NSF International against
NSFI/ANSI Standard 42 for the reduction of chlorine taste
and odor and Particulate Class II.