user manual installation | operation | specifications | features | maintenance spanish english
ContenTS Introduction Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Congratulations, you have purchased one of the most Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 effective, technologically advanced air purifiers available. Your New Fresh Air by EcoQuest . . . . . . . . . . . . . . . . . . . . .
Your New Fresh Air by EcoQuest Inspection & Installation • Eliminates smoke, odors, and tobacco smoke. 1. Remove protective packaging. • Includes "Certified Space Technology" Radiant 2. Remove unit from shipping carton. Catalytic Ionization (RCI), which incorporates the same process NASA uses to scrub the air inside spacecraft. • Germicidal, broad spectrum, high-intensity UVX lamp (100 - 300 nm). • Removes odors from your home, office, car, boat, RV, etc. 3. Remove all protective materials. 4.
operation 1. Adjust the fan speed to your preference, keeping in mind that higher fan speeds will give better results. 2. Using the Normal/High button, set the unit to 4. To operate the AWAY MODE feature, in unoccupied areas only,* press the Away Mode button until the desired time is reached (2, 4, 6, or 8 hours). The unit NORMAL, for typical use, or HIGH, for increased smoke will display AWAY MODE and the remaining time. To and odor control. interrupt the AWAY MODE, press the Normal/High 3.
settings and adjustments Fan UP Fresh Air by EcoQuest can be turned on or off, and Reminder Reset Purifier UP Away Mode ON/SET/OFF adjusted, using either the included remote or the control panel on the front of the unit. With the exception of the Reminder Reset button, both the remote and the control panel buttons have the same functions.
Maintenance Reminders General Maintenance (cont.) done more frequently. Shown here are basic procedures that should be carried out to keep your unit running at top performance. Replace plate For optimal performance, and to prevent damage not The purifier plate is not functioning properly. • Replace the old purifier plate with a new purifier plate (available from your local EcoQuest Business Owner). covered by your warranty, install the optional Fresh Air purifier pre-filter.
General Maintenance (cont.) Cleaning The Purifier Plate: Changing the RCI cell: Remove the rear lint screen (see pages 8 - 9). Carefully The RCI cell should be changed when REPLACE RCI remove the purifier plate from the card cage by grasping CELL appears on the display, or every three (3) years, the middle of the edge nearest to you, and slowly pull it whichever comes first. To change the RCI cell, follow the straight out. instructions on pages 8 - 9.
Removing the Rear Lint Screen 1 To Remove: 1. Unplug unit. Rear Lint Screen follow steps 1 - 5 Purifier Plate follow steps 1 - 6 2 2. R emove the back cover screw. RCI cell follow steps 1 - 10 3 3. R emove back cover. Press the sides to unlatch, then tilt the bottom out to remove. 4 5 7 8 4. R emove two thumbscrews securing the top of the lint screen. 5. R emove the lint screen by pulling back the top, then lifting up and out. Removing the Purifier Plate & RCI cell 6 6.
Installing the RCI cell & Purifier Plate To Install: Rear Lint Screen follow steps 5 - 9 purification plate, be Purifier Plate follow steps 4 - 9 making contact with RCI cell follow steps 1 - 9 1 1. S lide the RCI cell up and into the unit. Be sure the back lip of the RCI cell engages the two slotted protrusions at the rear of the plate cage, and that the angle brackets and studs are correctly aligned. When installing the sure the metal tabs are the screen on each side of the plate. 2 2.
Troubleshooting Indicators of Operation: "Maintenance" section of this Owner's Manual. Order When the unit is on, the LCD display will show either new purifier plates from your EcoQuest Business Owner. the fan setting and NORMAL, or the fan setting, purifier • The electrical stainless steel contacts are not contacting setting, and square footage. If the unit is in Away Mode, the screen portion of the purifier plate.
Troubleshooting Problem: Too much ozone accumulation, within the environment, as a result of improper purifier control setting, and/or lack of air movement. • Symptom: Visual haze of smoke and/or particulate remain within the environment. Problem: Lack of ionization and/or air movement. 6. Air flow is restricted or reduced. • Is the unit properly placed away from objects that may obstruct air flow? • Are the rear lint screen, back cover, and front grill clean? • Is the RCI cell clean? 7.
FCC DECLARATION OF CONFORMITY Name: EcoQuest Model: Fresh Air by EcoQuest This equipment has been tested and found to comply with the limits Manufacturer: EcoQuest Manufacturing for Industrial, Scientific, and Medical Equipment (ISM), pursuant to Part 18 of the FCC Rules. These limits are designed to provide This device complies with Part 18 of the FCC Rules. reasonable protection against harmful interference in a residential installation.