Full Product Manual
5
US
Your dehumidier uses DryFan
®
technology and
uses a continuously rotating moisture absorbing
patented wheel termed a “Rotor”.
A highly ecient yet low noise fan draws air into the
unit (Process Air) and forces it through a section of
the rotor. As the air passes through the rotor, the
honeycomb, of hygroscopic membranes absorbs
almost all of the moisture creating an extremely
dry air-stream.
Most of this air-stream (approx 85%) is discharged
directly through the ‘Dry Air Outlet’.
However, a portion (approx 15%) of this air (Regen
Air) is separated and directed through a special
heater bank (Regen Heater) where the air’s
temperature is raised.
This heated air is then channeled back through a section of the Rotor.
As this hot air passes through the membranes, its higher temperature drives-out the previously
absorbed moisture and discharges it as warm wet air through the ‘Wet Air Out’ duct.
As the wheel rotates, this process of collecting and discharging moisture is continuous.
The wet air outlet is 1.5 inch in diameter making it easy to vent the moisture away using standard push t waste
water connectors.
Water is not drained away as a liquid, it is vented away similar to a tumble dryer.
HOW OUR UNIQUE TECHNOLOGY WORKS |
• damp air in
• patented
regen heater
• dry filtered
air out
•wet air exhaust
• patented dessicant rotor
+