Specifications

17 © Copyright 2004 - 2009 The Fire Company Pty Ltd. All rights reserved. V5 0709.
How to operate the EcoSmart™ FireENGLISH
Re-igniting the EcoSmart™ Fire
1. Check that the Burner is at room temperature. If not, wait until the Burner has cooled. As a guide, it will
take approximately 15 to 30 minutes depending on when and for how long it was last operated.
2. Move the slider/hinge so Burner opening is fully open.
3. Allow for any residual fumes to evaporate (this will take a few minutes – please be aware that if this time is
not respected the ignition will be pressurized and therefore stronger).
4. Re-ignite as described in “Lighting the EcoSmart™ Burner”.
WARNING!
• Neverleaveareunguarded.
• OnlyuseDenaturedEthanol*intheEcoSmart™Burner.
• IgnitionofthelightingrodshouldonlybeperformedaboveandbesidetheBurnertoavoiddrippingthe
fuel at any stage of the lighting process out of the firebox onto the floor.
• TheEcoSmart™BurnermustnotbelledatanytimewithadditionalDenaturedEthanol*whenthe
flame is going or when the Burner is hot.
• AninherentdangerwithDenaturedEthanol*isthattheameproducedisalmostinvisibleinnormal
daylight conditions or first lit. Being difficult to see, an inexperienced person can easily assume
the Burner is empty and needs filling.
It is potentially lethal to attempt to refill the EcoSmart™ Burner when it is still lit. The result could
easily be an explosion. If it is necessary to refill the Burner, assume it is still burning and go through
the normal procedure of extinguishing the flame. Wait until the burner is at room temperature before
refilling and follow all instructions carefully.