User Manual

TOOLS NEEDED:
Philips screwdriver
INSTALLATION
OF THE
G3
LENS FRAME
FOR THE
RADION XR30w
View the video at
www.ecotechmarine.com/G3lensframeinstall/
View the video at
www.ecotechmarine.com/G3lensframeinstall/
®
610 954 8480
800 785 0338 (toll free)
888 500 2907 (fax)
INCLUDED IN LENS FRAME KIT:
Lens Frame (1), Fan Gasket (1)
• Before starting this process, ensure that
your Radion XR30w is disconnected from its
power supply.
• Place the Radion on a soft surface to protect
the cover plate from scratches.
• EcoTech Marine recommends the use of gloves
during this process to prevent any fingerprints
from getting on the LED clusters. Fingerprints
could cause a decrease in light output.
• EcoTech Marine is not responsible for any
damage caused to the Radion, your aquarium
and its livestock, or your property as a result
of improper use of the G3 lens frame.
• Installation of the G3 lens frame will not affect
your existing warranty of the Radion XR30w.
STEP 3: LIFT LENS FRAME OUT OF RADION
AND DISCARD.
STEP 4: REMOVE THE ADHESIVE BACKING ON
THE FAN GASKET AND ADHERE GASKET TO FAN MAK-
ING SURE TO LINE UP HOLES PRECISELY AND FOLD
DOWN EDGES.
STEP 1: REMOVE PHILLIPS FAN SCREWS
(4) AND REMOVE FAN GRILL ASSEMBLY (2 PIECES)
AND SET ASIDE.
STEP 6: INSERT FAN SHOULDER
SCREWS (4) AND TIGHTEN.
STEP 2: REMOVE PHILLIPS LENS FRAME
SCREWS (4) AT OUTER CORNERS AND SET ASIDE.
XR776 RETROFIT LENS FRAME KIT
YOU HAVE SUCCESSFULLY
UPDATED YOUR
RADION XR30w WITH
G3
LENS FRAME
STEP 7: INSERT THE LENS FRAME
SCREWS (4) INTO THE CORNERS OF THE LENS
FRAME AND TIGHTEN.
STEP 5: TAKE G3 LENS FRAME, REMOVE
PROTECTIVE FILM AND SET INTO YOUR RADION
HEAT SINK.