Instructions / Assembly

2pcs SMD3535 LED

Solar panel and light sensor

Rechargeable

Solar Motion Sensor 155028

Read these instructions carefully before first use.

PRODUCT DESCRIPTION

FEATURES & SPECIFICATIONS

The Solor Motion Sensor LED Light is used in outdoor and charge the solar panel at daytime. It will turn

on automatically when a movement is detected in dark places or when the light is dim. It will turn off

automatically after 12±2 seconds. It does not need any remote control or to touch the ON/ OFF switch.

Note: If there is little difference between the temperature of the moving person and that

of the background (e.g., in summer heat), the 10-meter ran drop by as much as 50%.

• Solar panel: Monocrystal silicon, 5.5V 0.8W

• Light Source: 2pcs SMD3535 LED, providing approx 180 lumen brightness

• Power supply: 1pc 18650 1400mAh 3.7V Li-ion rechargeable battery (included)

• Function switch: OFF / ON

OFF: Power off

ON: PIR motion sensor mode, steady white light with approx 180 lumen

• Charging time: ＞9 hours

• Time delay: 12±2 sec (Auto-delay function)

• Sensor distance: 0-10m

• Sensor angle: 120°

• Protection Grade: IP65

• Installation height: ＞2.5m

12±2 sec Auto-delay

TOP VIEW

10m

Auto-delay: The delay time of this light is 12s. The off timer(12s down to 0s) will start after the light detects a movement, but it will

reset to 12s when the light detects a movement again. The light only turn off automatically when don't detect a movement in 12sec.

PAGE 1
Solar Motion Sensor 155028 Read these instructions carefully before first use. PRODUCT DESCRIPTION Solar panel and light sensor Rechargeable 2pcs SMD3535 LED FEATURES & SPECIFICATIONS The Solor Motion Sensor LED Light is used in outdoor and charge the solar panel at daytime. It will turn on automatically when a movement is detected in dark places or when the light is dim. It will turn off automatically after 12±2 seconds. It does not need any remote control or to touch the ON/ OFF switch.
PAGE 2
INSTALLATION (A) Turn the switch to the desired position, and operate it according to the functional specifications ON / OFF before mounting the light. (B) Mount the light to a desired location with included hardware. NOTE: 1. For the first time use, insert the battery, and then charge the solar product by placing it under direct sunlight for several hours before using. 2. When the solar product is not in use for a long time, please remove the battery and store in a cool and dry place to avoid the leakage.