Operating Guide

6. Troubleshooting

No. Malfunction Possible Causes Solutions

WINBOT moves in an irregular

pattern during cleaning.

There is too much dirt and debris on the

window.

A. Spray additional Cleaning Solution on the Cleaning

Pad.

B. Clean the Driving Treads as described in section 4.

C. Replace the Cleaning Pad and restart the cleaning

cycle.

D. Use the Remote Control to control the cleaning by

pressing Direction Buttons.

* WINBOT is intended to be used for maintenance

cleaning on common windows. The product is NOT

designed to replace heavy duty or rst time cleaning.

WINBOT is stuck, and cannot

move, be controlled by the

Remote Control, or be reset by

pressing RESET.

Insufcient suction or Edge Detection Sensor

signal abnormity.

Press the RESET Button on the Remote Control and then

press and hold it until the WINBOT Status Indicator Light

glows a continuous BLUE or Safety Pod Status Indicator

Light glows a continuous GREEn to switch WINBOT to

Manual Override Mode. In Manual Override Mode, the

Direction Control Buttons on the Remote Control are

activated. Use the Direction Control Buttons to move

WINBOT to a position away from edges and where you

can safely reach it. Remove WINBOT from the window

and power OFF. Power ON and restart.

*When using the Manual Override Mode, do not leave

WINBOT attached to the glass unattended.

If the problem persists, please contact Customer Service.

8 WINBOT will not charge. WINBOT is not powered ON.

Move the robot’s Bottom Power Switch

to the ON position.