EN Instruction Manual Note: This Instruction Manual applies to units purchased in North America only.
Congratulations on the purchase of your ECOVACS ROBOTICS DEEBOT! We hope it brings you many years of satisfaction. We trust the purchase of your new robot will help keep your home clean and provide you with more quality time to do other things. Before you go any further, please register your product on the ECOVACS ROBOTICS website at www.ecovacsrobotics.com/registration/. We also suggest you record your model number, serial number, date of purchase and attach your receipt to this page for safekeeping.
Contents 1. Important Safety Instructions.......................................................................2 2. Package Contents and Technical Specifications.......................................4 2.1 Package Contents.....................................................................................4 2.2 Specifications............................................................................................4 2.3 Product Diagram.......................................................................
1. Important Safety Instructions When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE. SAVE THESE INSTRUCTIONS 1. This Appliance is not intended to be used by children under 8 or anyone lacking knowledge on proper use. Supervision may be necessary. Do not allow children to sit on or play with the Appliance. 2. Clear the area to be cleaned.
1. Important Safety Instructions 22. Turn OFF the power switch before cleaning or maintaining the Appliance. 23. The plug must be removed from the receptacle before cleaning or maintaining the Charging Dock. 24. Remove the Appliance from the Charging Dock, and turn OFF the power switch to the Appliance before removing the battery for disposal of the Appliance. 25. The battery must be removed and discarded according to local laws and regulations before disposal of the Appliance. 26.
2. Package Contents and Technical Specifications 2.1 Package Contents Robot Charging Dock Remote Control (with batteries) Instruction Manual (4) Side Brushes Battery Pack (2) Advanced Wet/Dry Cleaning Cloths Advanced Wet/Dry Reservoir Sponge Filter and High Efficiency Filter Measuring Cup Reservoir Cleaning Solution 2.
2. Package Contents and Technical Specifications 2.3 Product Diagram Robot 5 1 2 9 10 11 13 14 15 6 3 7 8 12 4 1. Top Cover 2. Dust Bin 3. AUTO Mode Button 4. Anti-Collision Sensors 5. Anti-Drop Sensors 6. Charging Contacts 7. Main Brush 8. Driving Wheels 9. Universal Wheel 10. Battery Pack 11. Side Brushes 12. Advanced Wet/Dry Reservoir Slots 13. Multi-Function Cleaning Tool 14. Upgrade Port (for Customer Service only) 15. Infrared Receiver for the Remote Control Control Panel 1 1.
2. Package Contents and Technical Specifications Remote Control 11 1 1. LCD Screen 2. Return to Charger Mode Button 3. AUTO Mode Button 2 3 4. Direction Control Buttons 5. START/PAUSE Button 5 4 6. Time Scheduling Button 7. Set Current Time Button 7 8. Spot Cleaning Mode Button 6 8 9. Intensive Cleaning Mode Button 9 10 10. Edge Cleaning Mode Button 11. Infrared Emitter Dust Bin 1 1. Dust Bin Handle 2. Dust Bin Lock 2 3 4 5 6 3. Filter Net 4. Sponge Filter 5. High Efficiency Filter 6.
3. Operating and Programming 3.1 Notes Before Cleaning Before operating DEEBOT, take a few moments to survey the area to be cleaned and remove any obstacles. Remove power cords and small objects from the floor that could entangle the product. The product is not suitable for use on long-pile carpet. Before using the product near an area rug or on a short-pile area rug with tasseled edges, please fold area rug edges under themselves.
3. Operating and Programming 3.2 Quick Start 1 Charging Dock Placement Place the Charging D ock on a level floor surface against the wall with the base perpendicular to the ground. Keep the immediate area 1.5m (5’) in front of the charger and 0.5m (1.6’) on both sides of the charger clear of objects and reflective surfaces. Plug the Charging Dock in. 2 Install the Battery Pack Place the Battery Pack into the battery slot on the bottom of DEEBOT. Press the Battery Pack into the slot until it clicks.
3. Operating and Programming 5 Charge DEEBOT Remove the Advanced Wet/Dry Reservoir before charging DEEBOT. Place DEEBOT on the Charging Dock m a k i n g s u re t h e C h a rgi n g Co nt a c t s o n DEEBOT and the Charging Dock Pins make a connection. Charge DEEBOT for at least 4 hours before the first use. * button blinks when DEEBOT is charging and stops glowing when DEEBOT is fully charged. * Remove the robot’s battery if the robot will not be used for a long time.
3. Operating and Programming 7 Start Press the button on DEEBOT or the AUTO Mode Button on the Remote Control. DEEBOT starts to work immediately in AUTO Cleaning Mode. * To choose another Cleaning Mode, please refer to section 3.3 Cleaning Mode Selection for details. 8 Pause Pause DEEBOT by pressing the button on DEEBOT or the START/PAUSE Button on the Remote Control.
3. Operating and Programming 9 Power OFF Pause DEEBOT. Press and hold the button on the robot. DEEBOT is powered OFF when the button stops glowing. * When DEEBOT is not cleaning, it is suggested to keep it powered ON and charging instead of powered OFF. 3.3 Cleaning Mode Selection DEEBOT has several cleaning modes to choose from to effectively clean different floors. Cleaning modes are selected using the Remote Control. 1 AUTO Cleaning Mode This is the most commonly used mode.
3. Operating and Programming 3 Spot Cleaning Mode (2-5 minutes) This mode is applicable for an area of highly concentrated dirt or dust. In Spot Cleaning Mode, DEEBOT focuses on a specific area to clean. DEEBOT cleans the area in a spiral pattern and stops when it completes Spot Cleaning. 4 Edge Cleaning Mode This mode is good for cleaning the edges and corners of a room. In Edge Cleaning Mode, DEEBOT cleans along a border (e.g. wall).
3. Operating and Programming 3.4 Programming the Robot DEEBOT has a Time Scheduling function. DEEBOT can be programmed to automatically clean once per day, at a specific time, even if nobody is at home. The current time of day and the cleaning times are scheduled using the Remote Control. * All scheduled cleanings are performed in AUTO Cleaning Mode. * The Remote Control uses a 12-hour clock with “AM” and “PM” indicators.
3. Operating and Programming 2 Schedule the Cleaning Time Press button on the Remote Control and the “hour” (first two digits) flashes on the Remote Control Screen. button on the Remote Control to Press confirm and save the scheduled cleaning time. DEEBOT emits t wo beeps. DEEBOT automatically cleans at the scheduled cleaning time every day.
3. Operating and Programming 3.5 Optional Advanced Wet/Dry Mopping System DEEBOT has an Optional Advanced Mopping System using an Advanced Wet/Dry Cleaning C l o t h a t t a c h e d to a p ro p r i e t a r y Ad v a n ce d We t / D r y R e s e r vo i r. Th e w a s h a b l e / re u s a b l e Cleaning Cloth automatically damp mops and then dries the floor to a spotless clean. * Do not use the mopping system on carpet.
3. Operating and Programming Attach the Advanced Wet/Dry Reservoir to the bottom of the robot. Insert the tabs on the Advanced Wet/Dry Reservoir into the Advanced Wet/Dry Reservoir Slots on the bottom of the robot until you hear a click. 3 Start Select the desired Cleaning Mode. DEEBOT sweeps, lifts, vacuums, mops and dries in the selected mode.
4. Maintenance Before performing cleaning and maintenance, power OFF DEEBOT and unplug the Charging Dock. 4.1 Dust Bin and Filters Open DEEBOT’s Top Cover and remove the Dust Bin. Open the Dust Bin Cover and empty the Dust Bin. Remove the Sponge Filter and High Efficiency Filter. Pat the High Efficiency Filter clean. Do not rinse the High Efficiency Filter under water. Rinse the Sponge Filter, Dust Bin and Filter Net under running water.
4. Maintenance 4.2 Advanced Wet/Dry Cleaning Cloth, Advanced Wet/Dry Reservoir Cleaning the Advanced Wet/Dry Cleaning Cloth If the mopping system was used, remove the Advanced Wet/Dry Reservoir from the bottom of DEEBOT and remove the Cleaning Cloth. Empty any remaining water from the Reservoir. Wash the Advanced Wet/Dry Cleaning Cloth by hand or in the washing machine, and lay flat to dry.
4. Maintenance 4.3 Main Brush and Side Brushes * A Multi-Function Cleaning Tool is provided for easy maintenance. Handle with care, this cleaning tool has sharp edges. Cleaning the Main Brush Turn the robot over. Push both buttons on the Main Brush Cover and remove it. Remove the Main Brush. Use the Multi-Function Cleaning Tool to cut off and remove any hair tangled around the Main Brush. Cleaning the Side Brushes Remove the Side Brushes. Wipe the Side Brushes and their slots with a dry cloth.
4. Maintenance 4.4 Other Components Use the Multi-Function Cleaning Tool to cut off and remove any hair tangled around the Universal Wheel. Wipe the Anti-Drop Sensors with the brush or the felt side of the Multi-Function Cleaning Tool to maintain their effectiveness. Wipe the Charging Contacts and Charging Dock Pins with the brush of the Multi-Function Cleaning Tool or a dry clean cloth to maintain their effectiveness.
5. Troubleshooting Please use this chart to troubleshoot common problems using DEEBOT. No. 1 2 3 Malfunction DEEBOT will not charge. DEEBOT gets into trouble while working and stops. DEEBOT returns to the Charging Dock before it finishes clea ning. Possible Causes Solutions DEEBOT is not powered ON. Press and hold AUTO Mode Button on DEEBOT to power ON. DEEBOT has not made a connection with the Charging Dock.
5. Troubleshooting No. 4 5 22 FR-CA EN Malfunction DEEBOT will not clean automatically at scheduled time. Remote Control failure (effective control range of Remote Control is 5m (16’). Possible Causes Solutions Time Scheduling function is cancelled. Set Time Scheduling function as described in section 3.4. DEEBOT is powered OFF. Power ON DEEBOT. The robot’s battery is low. Keep DEEBOT powered ON and on the Charging Dock to make sure it has a full battery to work at any time.
DM81-AM01-IM2016R00