Operation Manual

EN
13
4. Maintenance
Turn the robot over and remove the Cleaning
Pads. Wipe the Edge Detection Sensors
clean with the provided Finishing Cloth to
maintain their effectiveness. (W730 ONLY)
Turn the robot over and wipe the Squeegee
clean with the provided Finishing Cloth to
maintain its effectiveness.
4.3 Driving Treads
Move the Power Switch on WINBOT 7 to the
CHARGE position.
Inspect the entire Driving Treads by using
and buttons on the Remote Control. Stop
the Driving Treads and clean any dirt on
them with the provided Finishing Cloth.
Edge Detection Sensors
Squeegee