Operation Manual

16
EN
3
Status Light
Indicator
RED after it is
powered ON,
or during cleaning.
WINBOT 7 has
encountered a problem.
A. Power OFF WINBOT 7 and
unplug it. Then plug in again and
power ON.
B. Reset WINBOT 7 by pressing
the RESET Button on the Remote
Control.
C. Check for stubborn stains on the
window. Clean the stains before
using WINBOT 7.
D. Check the Cupule for dirt or
damage. Clean the Cupule as
described in section 4. If Cupule is
scratched or damaged, replace it
with a new one.
E. Check the Cleaning Pads.
Replace Cleaning Pads if they are
dirty or too wet.
F. Check the Driving Treads for dirt
or grease. Clean the Driving Treads
as described in section 4.
G. Check WINBOT 7’s Bumper.
Gently pat on the Bumper to restore
it to its normal position.
H. Check the window for uneven
surface. Do not use WINBOT 7 on
windows with an uneven surface,
such as decaled, frosted, textured,
patterned, or coated glass.
I. Check the window for thick dirt.
Clean the window by hand and
use WINBOT 7 for regular cleaning
after that.
*WINBOT 7 is intended to be
used for maintenance cleaning on
common windows. The product is
NOT designed to replace heavy duty
or time cleaning.
6. Troubleshooting