Owner`s manual

10
3. SET RECHARGE (REGENERATION) TIME:
Press the SELECT keypad once to display 2:00 AM
(flashing) and RECHARGE TIME.
At the 2:00 AM RECHARGE TIME set-
ting, the softener begins regeneration
at 2:00 AM, ending no later than 4:00
AM. This is a good time in most house-
holdsbecausewaterisnotbeingused.
If a different RECHARGE TIME setting would be better for
your household, do the following.
Press the (↑)UP/DOWN(↓) keypads to set the desired
RECHARGE starting hour. Be sure to observe the AM-PM
as you did when setting the time of day.
NOTE: Each press of the UP/DOWN keypads changes
the display 1 hour. Continuous pressure on the UP or
DOWN keypad cha n ges the display twice each second.
4. SET EFFICIENCY, BACKWASH TIME AND
RINSE TIME:
Press and hold the SELECT button.
“ 0 0 0 --- --- ’ ” s h o u l d s h o w in d i s p l a y.
Press SELECT button once more to go
to Efficiency screen.
Press the UP or DOWN button to set the efficiency setting
either on or off.
NOTE: California regulations require the efficiency set-
ting to be ON for sale in California.
NOTE: When efficiency setting is set to
on, a n icon will show in the upper right
hand corner of the display.
Press the SELECT button once to go t o the backwash
time setting.
NOTE: Factory default for this setting is
7 minutes.
Press the UP or DOWN button to set the desired back-
wash time.
Press the SELECT button once to go to the rinse time set-
ting.
NOTE: Factory default for this setting is
3 minutes.
Press the SELECT keypad once again, to return the
present time (steady) of day.
CALIFORNIA EFFICIENCY REQUIREMENT
Your water softener has a “High Efficiency” feature with an “ON” or “OFF” setting. This softener setting is shipped
in the “OFF” position, which utilizes the maximum rated capacity while most often achieving maximum salt
efficiencies. When installing this unit in the State of California, you MUST turn this setting to the “ON” position
which may initiate more frequent recharges, however it will operate at 4000 grains per pound of salt or higher.
IfyouwishtoturntheSaltEfficiencyfeature“ON”(
icon will show in display), follow the instructions on this
page.