2.
Quick Start 1 2 3 4 5 6 Open Cap on the bottom of both of your speakers Turn on the Main Power Switches on both speakers Press the Standby Power Button on top of your speakers to power them on The speakers will automatically pair to each other and announce which speaker is the Left / Right speaker. Search your Bluetooth Connection on your Smart Device. Two ‘ECOXGEAR’ options will be available. Choose either.
Control Buttons & Operations On/Off Press the Standby Power Button once to power ON/OFF. IMPORTANT: Standby Power function will NOT operate when the Master Power is set OFF. Master Power Switch under the cap on the back panel must be set ON for Standby & your speakers to operate. Bluetooth When turned ON, the 2.5” Mounted Speakers will power on and search for your Bluetooth. Refer to Set Up Recommendations 1-2-3 part 3 for details. EcoConnect Functionality is only available between two units.
Set Up Recommendations 1-2-3 1 Charge Your 2.5" Mounted Speakers Before you power on your 2.5” Mounted Speakers, connect the USB Micro port to the USB cable and a 5V power source to fully charge your speakers for best performance. NOTE: Before using your 2.5” Mounted Speakers for the first time, charge the speakers until all battery level indicators are green, indicating a full charge. Approximately 3 hours of charging is required from a low to a full charge.
SAFETY ADVISORY & WARNING: Read and follow all instructions. Use only as intended. CAUTION: Do NOT open to repair. A qualified technician must carry out repair work. ATTENTION: Do NOT charge while the unit is wet. Towel dry the unit AND make sure all connections are dry BEFORE plugging in the charging connector. Failure to do so may result in electrical damage to the unit and may void the warranty. PROPOSITION 65 WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov WARNING: 2.
EcoConnect - Wireless Stereo Connection of Two Speakers If the speakers do not automatically pair when they are first turned on, PRESS & HOLD on each speaker for 5 seconds. Once the speakers emit a tone, follow the Bluetooth Pairing & Audio instructions to connect one 2.5” Mounted Speaker to your device. Leave this speaker powered on and connected to your device. Next, press the EcoConnect Button on both of your speakers. Both speakers will announce, “EcoConnect, pairing speakers.
Master Power Switch & Connections To access the connections, turn the cap to the LEFT so the cap’s arrow point lines up with unlocked symbol , on the back of the unit. Use the finger tab to pull open the cap. 2.5" Mounted Speakers Select Unlocked 2.5 2. 2 .5 ˝ WATERPROOF W ATE ERPROOF F BLUETOOTH B LUE ETOOT TH® MOUNTED M OUNTED D SPEAKER S PEA AKER Use Tab to Open Cap Access Connections x2 USB Cables Models: M odels: GDI-EXYMH2X GDI-EXYMH2X2500...2520 X2500...
Connections: Functions Audio AUX-IN Specifications Unit Dimensions Connect an audio device using the 3.5mm cable connection as an alternative to a Bluetooth connection to your 2.5” Mounted Speakers. NOTE: Volume level must be controlled from the audio device when connected to the AUX-IN connection. 4.3” 2.8” Input Master Power Switch 2.5” Mounted Speakers have a separate Master Power Switch and a Standby Button. The switch MUST be set to the ON position to power your speakers.
FCC Warning Statement Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
