Care and Maintenance Instructions

8
Pairing a Bluetooth Device
1. Turn on your Bluetooth device.
2. Power on SoundExtreme. “Speaker on, ready to connect” voice
prompt will be heard. If the Bluetooth LED Indicator (the second
LED Indicator from the left) is not flashing, briefly press to
start pairing your device.
3. Navigate to your Bluetooth device’s setup screen, find
ECOXGEAR and connect. If the connection is successful, the
Bluetooth icon will be lit solid and your SoundExtreme will
announce “Your phone is connected.”
Notes:
· If the pairing is not complete within 5 minutes, the speaker will
exit the pairing mode. You need to repeat the pairing steps again.
· After the connection is successful, if you turn the speaker off
and turn it on again, it will reconnect to the last connected
device automatically. Also, a voice prompt, “Speaker on, ready to
connect” followed by, “Your phone is connected” will be heard.
· PRESS AND HOLD for 5 seconds to clear all pairing records.
Adjust Volume
1. Press or briefly to adjust the speaker volume.
2. PRESS AND HOLD or to adjust the volume continuously.
a. Press briefly to increase one volume level. PRESS
AND HOLD to keep increasing the volume until
maximum volume level is reached.
b. Press briefly to decrease one volume level. PRESS
AND HOLD to keep decreasing the volume until
minimum volume level is reached.
13
Remote Control
Pairing Your
Remote Control
Before you use your Remote Control
for the first time, pull and remove
the plastic tab at the bottom of the
Remote Control. Your Remote Control
should be paired to your unit. IF NOT
paired, please follow the steps below.
1. Connect the SoundExtreme to a 12V
power supply. (Refer to Connecting
to 12VDC Power Supply for details.)
2. Within 15 seconds, PRESS AND
HOLD for 3 seconds. Your
Remote Control will be paired with
your SoundExtreme.
3. Verify that your remote control
works by pressing the to see
if the speakers light up.
If the speakers do not light up, unplug the 12V power supply, then repeat
the above steps.
Once the remote is paired with the SoundExtreme, it will remain stored
in the SoundExtreme’s memory and should not need to be paired again.
Audio
Power On: PRESS AND HOLD for 3 seconds to power on the
SoundExtreme. “Speaker on, ready to connect” voice prompt will be heard.
Power Off: PRESS AND HOLD for 3 seconds to power off
the SoundExtreme.
Press briefly to cycle through the following modes: Bluetooth,
EcoCast Transmitting, EcoCast Receiving, FM, and AUX-IN.
REMOTE
CONTROL