SoundExtreme SE18 Models: GDI-EXSE1800...
What’s in the Box SoundExtreme SE18 8ft Power Cable SoundExtreme SE18 Models: GDI-EXSE1800...20 POWERSPORTS AMPLIFIED SOUNDBAR Auxiliary Power Out Mating Connector User Guide SoundExtreme SoundExtreme User Guide Remote Control (2x) Rubber Sleeves Allen Wrench for ¼-20 (2x) Mounts (2x) Rubber (4x) Worm Clamps Feet - ½˝ Width 20 (2x) ¼-20 SHCS Bolt – 3.5” long (2x) ¼-20 SHCS (2x) ¼-20 Stud – 1.5˝ long Bolt – 2˝ long (2x) ¼-20 SHCS Bolt – 1.25˝ long (2x) ¼-20 SHCS Bolt – 0.
SoundExtreme SE18 Layout Control Panel Backlit Speakers FRONT Backlit Woofer LEFT SIDE Auxiliary Power Out SAE Connector (Black) RIGHT SIDE 12V Power In SAE Connector (Red) BACK 2 Backlit Woofer Light Bar
In/Out Connections USB Charging AUX-IN Port Port (Black) AUX-OUT Port (Gray) Do NOT use these connections if they are wet. AUX-IN: This input can be used to connect a CD player, MP3 player, etc. AUX-OUT: This output can be used to connect to an amplifier or to another speaker AUX-IN connection. USB Charging Port: Connect your device’s charge cable here to charge it. USB charging only functions when the SoundExtreme’s power is turned on. USB port rating is 5V, 2.1A.
Connecting to 12VDC Power Supply The SoundExtreme does not have an internal battery. It must be connected to an external 12VDC power supply to function. When you install the SoundExtreme to a battery or a voltage regulator on a golf cart, a boat, a quad bike, a UTV, or another vehicle, you need to make sure that your vehicle battery or battery pack terminal voltage is 12VDC. If the battery terminal voltage is not 12V, you will need a DC–DC converter with output 12V.
Installation: Gas Vehicle 1. Loosen the bolts on the battery terminals. Use Caution: Do NOT attempt to loosen bolts if battery is wet. Contact may cause electric shock and injury if wet. 2. Connect the BLACK wire to the BLACK, negative terminal, then the RED wire to the RED, positive terminal. Unit will not work correctly and may be damaged if wires are not correctly attached. Loosen Bolts 3. Tighten the bolts on the battery terminals until the connectors are held firmly in place. 4.
Controls 1. LED Indicators: Each of the 4 LEDs correspond to different functions: Power, Bluetooth, Mode, and Status. 1 2 2. Power Button: Press button to turn the SoundExtreme on / off. 3. Mode Button: Press button to cycle through the following modes: Bluetooth, EcoCast Transmitting, EcoCast Receiving, FM, and AUX-IN. 3 4 5 6 7 8 9 4. Volume Control Buttons: Press to adjust the speaker’s volume. Press and hold to adjust the volume continually. 5.
Operations LED Indicators From left to right, the 4 LED Indicators correspond to Power, Bluetooth, Mode, and Status. 1. Power Solid Green: Power On No Light: Power Off 2. Bluetooth Flashing Blue: Bluetooth Paring Solid Blue: Bluetooth Connected 3. Mode Solid Blue: Speaker Mode Solid / Flashing Red: EcoCast Transmitting Mode Solid / Flashing Green: EcoCast Receiving Mode 4.
Pairing a Bluetooth Device 1. Turn on your Bluetooth device. 2. Power on SoundExtreme. “Speaker on, ready to connect” voice prompt will be heard. If the Bluetooth LED Indicator (the second LED Indicator from the left) is not flashing, briefly press to start pairing your device. 3. Navigate to your Bluetooth device’s setup screen, find ECOXGEAR and connect. If the connection is successful, the Bluetooth icon will be lit solid and your SoundExtreme will announce “Your phone is connected.
Play Music (Bluetooth Mode) After the SoundExtreme is connected to your Bluetooth device, press briefly on the SoundExtreme to play, press again to pause. Press briefly to play previous song. Press next song. briefly to get the Notes: · Pair and connect your Bluetooth device with SoundExtreme before using this feature. · If a call is received when you are listening to music, press briefly on the SoundExtreme to answer the call. Press again to end the call.
EcoCast – Broadcast Your Music to Multiple Speakers x100 When you have two or more SoundExtreme speakers, you can build a broadcast system by initiating EcoCast Transmitting Mode in one SoundExtreme speaker and broadcasting your music to one or more SoundExtreme speakers in EcoCast Receiving Mode. EcoCast: First Two Speakers A B 1. Follow the Pairing a Bluetooth Device instructions to connect one SoundExtreme (Speaker A) to your Bluetooth device.
EcoCast: Additional Receiving Speakers B A C D 1. Power on the additional SoundExtreme speaker(s) (Speaker C and Speaker D). Press to cycle through to and initiate EcoCast Receiving Mode. The Mode LED Indicator will flash Green, and the speaker(s) will announce, “EcoCast receiving.” 2. On Speaker A (the speaker with the Mode LED Indicator shining solid Red), PRESS AND HOLD for 6 seconds. The Mode LED Indicator will flash Red. 3.
Listening to FM Radio (FM Mode) Press briefly to cycle through to FM Mode. Press or briefly to tune in a radio station. To “seek” (jump to the next available station), PRESS AND HOLD either button down for a few seconds until it starts to seek a station. When you tune and listen to a station, you can PRESS AND HOLD to assign the current station to Preset 1, or PRESS AND HOLD to assign the current station to Preset 2.
Remote Control Pairing Your Remote Control Before you use your Remote Control for the first time, pull and remove the plastic tab at the bottom of the Remote Control. Your Remote Control should be paired to your unit. IF NOT paired, please follow the steps below. 1. Connect the SoundExtreme to a 12V power supply. (Refer to Connecting to 12VDC Power Supply for details.) 2. Within 15 seconds, PRESS AND HOLD for 3 seconds. Your Remote Control will be paired with your SoundExtreme. 3.
After the SoundExtreme is connected to your Bluetooth device, press briefly to play, press again to pause. Press briefly to play previous song. Press next song. Press or briefly to get the briefly to adjust the speaker volume. LED: Backlit Speakers Press Press briefly to turn on your speaker backlights. or briefly to cycle through the 6 Party Light modes. LED: Light Bar Press Press briefly to turn on your Light Bar. or briefly to cycle through the 5 Light modes.
Mounting Your Speaker 1. To mount the speaker, first place the 2 Mounts on the ends of the SoundExtreme at your desired orientation and attach them using three or four (depending on the orientation of your mount) Button Head Bolts, each. Tighten securely. 2. Ensure that the speaker fits in the desired location and mark where the mounts will be attached to your vehicle. 3. Drill holes at the desired mounting points on your vehicle, large enough for the provided ¼-20 Bolts to fit. 4.
Troubleshooting The sound is distorted Try lowering the volume control of your connected device or musical instrument. Also, try to reduce the overall volume of the SoundExtreme. Cannot Pair With Bluetooth Device Make sure that your device is compatible with Bluetooth. Turn off your SoundExtreme and Bluetooth device, then power on and reconnect. Make sure that Bluetooth mode is selected on your SoundExtreme. If there is poor FM reception To adjust FM reception, move entire product.
Specifications 4.5 in / 114.3 mm Dimensions 4.5 in / 114.3 mm Unit + Mounts Height 5.75 in Unit Weight 8 lbs Bluetooth Compliance Bluetooth V 5.0 Bluetooth Frequency Band 2.402~2.480GHz ISM Spectrum Modulation GFSK, π/4-DQPSK, 8DPSK Bluetooth Range Up to 100 ft / 30m Tweeter (1x) 1'' (25.4 mm) tweeter Woofer (2x) 4'' (101.6 mm) woofer Mid-Range Speaker (2x) 2.25'' (57.
FCC STATEMENT: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1.) This device may not cause harmful interference, and 2.) This device must accept any interference received, including interference that may cause undesired operation. WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
3.) Properly clean the ECOXGEAR and ensure the gaskets have no sand, dirt, or water on them prior to storage. 4.) Store your unit with all caps properly sealed to avoid long term internal moisture damage inside your unit. 5.) Return the ECOXGEAR to Grace Digital if you suspect water ingress into the unit or if the unit has experienced a severe impact that may have affected the integrity of the unit to take on water. You should never 1.) Never power your ECOXGEAR if you suspect water has entered the device.
Pairing the SoundExtreme with Your Remote Control Before you use your Remote Control for the first time, please follow the steps below. STEP 1 Pull and remove the plastic tab at the bottom of the Remote Control. Your Remote Control should be paired to your unit. IF NOT paired, complete Step 2. STEP 2 Pair your Remote Control with the SoundExtreme. a. Connect the SoundExtreme to a 12V power supply. (Refer to Connecting to 12VDC Power Supply in the User Guide for details.) b.
Product Warranty Registration To register your purchased product, please visit: www.ecoxgear.com/register or please enter all fields below and return this postal card by mail NAME: ADDRESS: CITY, STATE, ZIP: EMAIL: PRODUCT MODEL: DATE OF PURCHASE: PLACE OF PURCHASE: Please note: Product registration does not constitute proof of purchase for the warranty process. Please keep all receipt and purchase records as your evidence of the date and place of purchase.
Insert Postage Here O E