Owner's Manual

13
Remote Control
Pairing Your
Remote Control
Before you use your Remote Control
for the first time, pull and remove
the plastic tab at the bottom of the
Remote Control. Your Remote Control
should be paired to your unit. IF NOT
paired, please follow the steps below.
1. Connect the SoundExtreme to a 12V
power supply. (Refer to Connecting
to 12VDC Power Supply for details.)
2. Within 15 seconds, PRESS AND
HOLD for 3 seconds. Your
Remote Control will be paired with
your SoundExtreme.
3. Verify that your remote control
works by pressing the to see
if the speakers light up.
If the speakers do not light up, unplug the 12V power supply, then repeat
the above steps.
Once the remote is paired with the SoundExtreme, it will remain stored
in the SoundExtreme’s memory and should not need to be paired again.
Audio
Power On: PRESS AND HOLD for 3 seconds to power on the
SoundExtreme. “Speaker on, ready to connect” voice prompt will be heard.
Power Off: PRESS AND HOLD for 3 seconds to power off
the SoundExtreme.
Press briefly to cycle through the following modes: Bluetooth,
EcoCast Transmitting, EcoCast Receiving, FM, and AUX-IN.
REMOTE
CONTROL