Operation Manual

40
Using BIOS
Onboard 1394 Device (Enabled)
Enable this item if you plan to use the 1394 device.
Onboard LAN Device (Enabled)
Use this item to enable and disable the onboard LAN function.
Onboard LAN Boot ROM (Disabled)
Use this item to enable or disable the booting from the onboard LAN or a network add-in
card with a remote boot ROM installed.
IDE HDD Block Mode (Enabled)
Enable this field if your IDE hard drive supports block mode. Block mode enables BIOS to
automatically detect the optimal number of block read and writes per sector that the drive
can support. It also improves the speed of access to IDE devices.
Power Management Setup
This option lets you control system power management. The system has various power-
saving modes including powering down the hard disk, turning off the video, suspending
to RAM, and software power down that allows the system to be automatically resumed
by certain events.
ACPI Suspend Type (S3(STR))
Use this item to define how your system suspends. In the default, S3 (STR), the suspend
mode is suspend to RAM, i.e., the system shuts down with the exception of a refresh current
to the system memory.
Suspend Mode (Disabled)
The CPU clock will be stopped and the video signal will be suspended if no Power Manage-
ment events occur for a specified length of time. Full power function will return when a
Power Management event is detected.
Video Off Option (Susp, Stby —> Off)
This option defines if the video is powered down when the system is put into suspend mode.
Video Off Method (DPMS Supported)
This item defines how the video is powered down to save power. This item is set to DPMS (Display
Power Management Software) by default.
ACPI Suspend Type [S3(STR)]
Suspend Mode [Disabled]
Video Off Option [Susp, Stby -> Off]
Video Off Method [DPMS Supported]
MODEM Use IRQ [Auto]
HDD Off After [Disabled]
Power Button Override [Instant Off]
Power On After Power Fail [Off]
PM Wake Up Events [Press Enter]
Item Help

Menu Level
Phoenix-AwardBIOS CMOS Setup Utility
Power Management Setup


F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help