User manual

ECTACO iTRAVL
®
User Manual
11
• Connect the AC/DC adapter to your device via the mini-USB port (see General View),
or connect your device to your PC using the special USB cable or USB cradle.
The red LED signal shows that the battery is recharging and the blue one shows it is
charged.
SD CARD
Before you start using your ECTACO iTRAVL
®
, please make sure the SD card (included
in the standard package) is installed into the SD slot of the device. If the card is not
installed, slide it into the slot located on the left edge of the device – the label of the card
face up, contacts face down. Push the card gently until it clicks into place. To eject the
card, just push it in slightly.
♦ Note: If the SD slot is covered, please detach the slot cover before you install the card.
INITIALIZATION
In the rare event that the data on the screen is corrupted or a program is not responding
properly, you will need to perform a reset.
The Reset button is located on the back of the device (see General View).
• Press the Reset button with the tip of the stylus. Never use a needle or a pin since it
can damage the device.
On completion of the reboot, you will see the calibration screen with five targets,
appearing one after another as you tap them with the stylus.
DISPLAY AND MAIN MENU
ECTACO iTRAVL
®
features a touch screen (240 x 320 pixels) with a windows-driven
graphical interface. The Main Menu consists of four sections, which visually organize
access to the ECTACO iTRAVL
®
applications.
♦ Note: Tapping screen items is preferably done with the supplied pointing device
known as a stylus, which, when not in use, is kept in a special slot at the side of the
device's back panel (see General View).
Main Menu
• To display the Main Menu, turn the device on, exit the currently running application
and close the current section. The Main Menu consists of the following sections:
iTRANSLATE, iTRAVL, Extras, and iHELP.
At the top of the screen, you will see the battery life indicator.