User`s manual

ECTACO Partner
®
X8 Quick Start
5
according to the polarity marks (+ -) inside the compartment. If
you use the special rechargeable battery pack, make sure you
place it with the angled edge on top.
• e Put the battery compartment cover back in place by sliding it
toward the device.
• Make sure the cover sits in place properly. The device will not
work with an open battery compartment cover.
• Do not mix old and new batteries!
• Do not exceed the 2-minute limit!
• When the batteries are replaced, turn the device on to make sure
it works correctly.
How to recharge the accumulators
• Make sure the accumulators are inserted in the battery
compartment.
• Connect an AC/DC adapter to your device.
Use of an inappropriate external power supply may cause failure of
the device and void the warranty. The AC/DC adapter should provide
9V and min 300mA DC. Connect and disconnect the AC/DC
adapter only when the device is turned off!
The red LED (see General View) shows that the accumulators are
recharging and the green one shows that the accumulators are
charged. The recharge LED will glow when the adapter is connected
to the device.