User`s manual

Partner

X5 User's Manual

• Remove the battery compartment cover by sliding it away from

the device.

• Remove the used batteries and replace them with new ones.

♦ Note: Do not mix old and new batteries.

• Make sure to place the batteries according to the polarity

markings (+ -) inside the compartment.

• Put back the battery compartment cover by sliding it toward the

device. Make sure the cover sits in place properly.

• Turn the device on to make sure it works correctly.

♦

Note: You have 2 minutes to replace the batteries without risk of

losing the data stored in RAM. Do not exceed the 2-minute

limit! Neither the manufacturer nor the dealer may be held

responsible for the loss of user data.

Initialization

The initialization routine is started

• when the Partner

X5 is turned on for the first time

• when you remove the batteries (e.g. when replacing them)

for longer than 2 minutes

• after the system has been reset with the RESET button.

♦ Note: The RESET button is located on the right-hand side of the

keyboard (over the

button). It can be accessed with any thin

object like a paper clip. Never use a needle or a pin since it can

damage the device.

• If you see the Initialize system? message, press or touch

to abort initialization and customization.

• If you confirm the prompt, the factory defined settings will be

restored, but you can still prevent your data deletion by canceling

the ensuing prompt Delete all user’s data? Press

or touch

or to preserve your data.

The System is initialized! message signals that a system

initialization has been accomplished, freeing memory and restoring

the factory defined settings.