Service manual

Parametric output
Parametric output is used for the parametric control of the external actuators. Depending on the electric current
required by the actuator, direct controlling or controlling through an electric relay is possible.
The current drawn from the Power Out #2 cannot exceed 5A (eg. it can be used directly to control LED diode,
electrovalves, buzzer, etc.), .If the required current exceeds 5A (for example, fuel pump, water injection pump,
etc.), electric relay must be used. It is important to remember to connect an extra Ground to the 19 pin (Power
Ground) when using the Power Out #2 output.
Warning !
Current draw that exceeds 5A will damage the device!
Sample wiring diagrams
Connection of the LED diode (eg. Shift Light)
Connection of the fuel pump
Power Out #2 (18)
Power Ground (19)
DET 3
+12V
Fuel Pump
+12V
330R
+12V
Power Out #2 (18)
Power Ground (19)
DET 3