User Manual

5
EN
torment
™
• Neverinstalldamagedbatteries.
• Neverinstallbatteriesofmixedtypesorofdifferentagesin
the transmitter.
• Alwaysremoveexhaustedbatteries.
• Alwaysremovebatteriesbeforestoringthetransmitter.
• LowbatterypowercanresultinlossofcontroloftheRC
vehicle.
TRANSMITTER BATTERY SAFETY PRECAUTIONS
REMOVING THE VEHICLE BODY
INSTALLING THE BATTERY IN THE VEHICLE
1. Remove the front and rear body clips, then remove the battery
strap.
2. Install a fully charged battery.
3.Installthebatterystrap.
4. Install the front and rear body clips.
If desired, you can put foam blocks (ECX2015) in front of the battery
so the weight of the battery increases rear traction or in back of the
battery to increase steering response.
INSTALLING TRANSMITTER BATTERIES
1. Slide the panel open on the bottom of the transmitter.
2.Obeythebatteryplus(+)andminus(-)diagraminthe
transmitter to install 4 AA batteries.
3.Slidethepanelclosed.
We recommend using only alkaline AA batteries in the
transmitter.
CAUTION: If using rechargeable batteries, charge only
rechargeable batteries. Charging non-rechargeable
batteries may cause the batteries to burst, resulting in injury to
persons and/or damage to property.