Instruction manual

• Never install damaged batteries.

• Never install batteries of mixed types or of different ages in

the transmitter.

• Always remove exhausted batteries.

• Always remove batteries before storing the transmitter.

• Low battery power can result in loss of control of the RC

vehicle.

TRANSMITTER BATTERY SAFETY PRECAUTIONS

REMOVING THE VEHICLE BODY

INSTALLING THE BATTERY IN THE VEHICLE

1. Remove the front and rear body clips, then remove the battery

strap.

2. Install a fully charged battery.

3. Install the battery strap.

4. Install the front and rear body clips.

If desired, you can put foam blocks (ECX2015) in front of the battery

so the weight of the battery increases rear traction or in back of the

battery to increase steering response.

INSTALLING TRANSMITTER BATTERIES

1. Slide the panel open on the bottom of the transmitter.

2. Obey the battery plus (+) and minus (-) diagram in the

transmitter to install 4 AA batteries.

3. Slide the panel closed.

We recommend using only alkaline AA batteries in the

transmitter.

CAUTION: If using rechargeable batteries, charge only

rechargeable batteries. Charging non-rechargeable

batteries may cause the batteries to burst, resulting in injury to

persons and/or damage to property.