User Manual

5
EN
1:18 GEN2 4WD BRUSHED ROCK CRAWLER RTR
This transmitter requires 4 AA batteries.
1. Remove the battery cover from the transmitter.
2. Install the batteries as shown.
3. Install the battery cover.
CAUTION: If using rechargeable batteries, charge only
rechargeable batteries. Charging non-rechargeable batteries
may cause the batteries to burst, resulting in injury to persons and/or
damage to property.
CAUTION: Risk of explosion if battery is replaced with an
incorrect type. Dispose of used batteries according to national
regulations.
Power Switch
Power ON or OFF the transmitter
Reverse Switch
Allows you to change the direction of steering
(ST. REV) and throttle (TH. REV) controls (Ensure
proper function with a radio system test)
Steering Wheel
Controls RIGHT
and LEFT
steering
Solid Red: Battery voltage is
good (above 4V)
Flashing Red: Battery voltage
is critically low (below 4V).
Replace transmitter batteries
Battery Level Indicator
Steering Rate
Adjusts the amount the
front wheels move when the
steering wheel is turned left
or right
Throttle Dual Rate
Adjusts the maximum amount
of throttle the model can be
given
Adjusts the neutral point of
the electronic speed control
Throttle Trim
Adjust to make the model
drive straight with no input
at the steering wheel
Steering Trim
Throttle Trigger
Controls power
to the motor for
forward or reverse
Stop ReverseForward
TRANSMITTER CONTROLS
INSTALLING TRANSMITTER BATTERIES