Instruction manual

6
EN
circuit
TRANSMITTER CONTROLS
POWER
ST. TRIM
TH. TRIM
ST. RATE
BATTERY LEVEL
INDICATOR
Solid Green: Battery
voltage is good (above
4V).
Flashing Green: Battery
voltage is critically low
(below 4V). Replace
batteries.
THROTTLE TRIM
Adjusts the neutral point
of the electronic speed
control.
STEERING TRIM
Adjust to make the vehicle
drive straight with no input
at the steering wheel.
POWER SWITCH
Power on
or off the
transmitter.
POWER
BIND THST
N R N R
STEERING WHEEL
Control steering. Right and
Left steering with ST. REV
Switch on N
(see ST. REV switch).
THROTTLE TRIGGER
Controls power to motor for forward
or reverse (see TH. REV switch).
Stop
Reverse
(when TH.
REV switch
on R).
Forward
(when TH.
REV switch on R).
STEERING RATE
Adjusts the amount the
front wheels move when the
steering wheel is turned left
or right.
REVERSE SWITCH
Allows you to change the
direction of steering (ST. REV)
and throttle (TH. REV) controls
(default settings are “N” for
steering and “R” for throttle).
BIND THST
N R N R
The DX2E has a France RF Mode that complies with French
regulations. The DX2E must be in France mode when used
outdoors in France. At all other times, the transmitter should be
in Standard mode.
FRANCE MODE
Turn the wheel full left, pull the trigger full throttle, and hold
down the bind button while turning on the transmitter. The
Green LED will flash twice.
STANDARD MODE (DEFAULT PRESET SET AT FACTORY)
Turn the wheel full right, pull the trigger full throttle, and hold
down the bind button while turning on the transmitter. The
Green LED will flash once.
RF MODE