Instruction manual

10
EN
TORMENT
™
Description
Tapping Binder Head, M3x8mm
Tapping Binder Head, M2.5x4mm
Tapping Binder Head,
M3x10mm
Tapping Binder Head, M3x14mm
Tapping Binder Head, M3x16mm
Tapping Binder Head, M3x18mm
Tapping Binder Head, M3x20mm
Tapping Binder Head, M3x22mm
Tapping Binder Head, M3x25mm
Binder Head, M3x10mm
Tapping Flat Head, M2.5x10mm
Tapping Flat Head, M3x10mm
Tapping Flat Head, M3x15mm
Tapping Binder Head, M3x12mm
Washer,
6.2x10.8x0.2mm
Flanged Lock Nut, M4
Washer,
3x8x1mm
Lock Nut M3
Washer,
2.6x6 X0.5mm
Lock Nut M2.5
Setscrew, M3x3mm
Setscrew, M4x3mm
Binder Head, M3x20mm
Binder Head, M3x22mm
Flat Head, M3x8mm
Flat Head, M3x10mm
Flat Head, M4x18mm
Binder Head, M3x12mm
Binder Head, M3x14mm
Binder Head, M3x16mm
Binder Head, M3x18mm
Description Description Description
FASTENERS
SHOCK CLEANING
Oil-fi lled shocks will require regular maintenance due to the oil breaking
down or getting dirty. This maintenance should be performed after about
every 3 to 5 hours of use, depending on the conditions that the vehicle is
used in.
• Remove the shock from the vehicle.
• Remove the cap from the shock body and dispose of fluid.
• Disassemble the shock. Clean thoroughly with DYN5505. Dry parts
before assembly.
• Re-assemble the shock and refill the shock body with silicone fluid (30
weight recommended).
• Slowly move the shaft and piston up and down to remove air bubbles.
• Move the piston to the midway point of the body and install the cap.
• Wipe off any overflowing fluid.
• When properly filled, the piston should rebound about 3/8 in (9.5mm)
after being pushed in fully.
• Re-install the shock on the vehicle.
Ride Height Adjustment
Ride height is an adjustment that affects the way the vehicle jumps,
turns and goes over bumps. Drop one end of the vehicle from approxi-
mately 6 inches (152 mm) in height onto a fl at surface. When dropping
the front of the vehicle, after the vehicle settles, make sure the front
arms are equal and parallel to the fl at surface. Do the same with the rear
to make sure both arms are parallel with the fl at surface.
Lowering the front ride height increases steering, but decreases
traction. Lowering the rear ride height increases traction, but decreases
steering.
Part # Description
ECX233000 Shock, Complete, (2): 4wd
ECX233001 Shock Rebuild, (2): 4wd
ECX233002 Top, Bottom Shock Ends: 4wd
ECX233003 Shock Spring, Black, Set: 4wd
Part # Description
ECX234005 Link Set, Plastic: 1:10 4wd All
ECX236001 Lock Nut, M2.5, (5)
ECX236004 Special Hardware: 1:10 4wd All
ECX233000
ECX233001
ECX233002
ECX234005
ECX236001
ECX236004
ECX233001
ECX233002
ECX234005
ECX233003
SHOCK PARTS
DIAGRAM