User manual

EN
4
Transmitter
Frequency 2.4GHz
Modulation DSMR
Battery AAx4
Servo
Power Supply 4.8V~6V (shared with receiver)
Output Torque 199.8 oz-in (8.5 kg-cm)
Operating Speed 0.20 sec/60 degrees of travel
Size 55.6x18x30mm
Electronic Speed Control (ESC)
Input Voltage 7.4–11.1V
Constant/Peak 100 A/590 A
Resistance 0.0045 Ohm
Overload Protection Thermal
BECVoltage 6V/3A
Size 53.5mmx36mmx36mm
Weight 79 g
1
Included Items
1. ECX
®
Revenge Type e
™
1/8-scale Buggy
2. Spektrum
™
DX2E transmitter
• 3degreereartoeset
• Shock spacers
• Turnbuckle wrench
• L-wrenches: 1.5mm, 2mm, 2.5mm
Needed to Complete
• DYNC2020 Prophet
™
Sport Duo
Li-Po50Wx2DualBatteryCharger
• Dynamite
®
Gold Series
2Sor3SLi-PoBattery
2
POWER
ST. TRIM
TH. TRIM
ST. RATE
VEHICLE PREPARATIONS
1. Slide the panel open on the bottom of the
transmitter.
2. Obey the battery plus (+) and minus (-) diagram
in the transmitter to install 4 AA batteries.
3. Slidethepanelclosed.
We recommend using only alkaline AA batteries
in the transmitter, however, it is possible to use
rechargeable Ni-MH batteries.
CAUTION: If using rechargeable batteries, charge
only rechargeable batteries. Charging non-rechargeable
batteries may cause the batteries to burst, resulting in
injury to persons and/or damage to property.
INSTALLING TRANSMITTER BATTERIES
31 2
COMPONENTS
SPECIFICATIONS