Instruction manual

WHEN YOU ARE FINISHED

•Prolongmotorlifebypreventingoverheatingconditions.

Unduemotorwearresultsfromfrequentturns,stopsand

starts, pushing objects, driving in deep sand and tall grass,

and driving continuously up hill.

•Over-temperatureprotectionisinstalledontheESC

to prevent circuit damage, but cannot protect the

motor from driving against heavy resistance.

MOTOR CARE

1. Remove the body. 2. Power off the ESC and disconnect the battery.

4. Remove the battery from the vehicle and recharge the battery.3. Poweroffthetransmitter.

MAINTENANCE

SETTING THE GEAR MESH

The gear mesh has already been set at the factory. Setting the

gear mesh is only necessary when changing motors or gears.

Proper gear mesh (how the gear teeth meet) is important to the

performance of the vehicle. When the gear mesh is too loose, the

spur and pinion gears could be damaged. If the mesh is too tight,

speed could be limited and the motor and ESC will overheat.

Set the gear mesh by following these simple steps:

1. Loosen the 2 motor screws.

2. Put a small piece of paper (A) between the pinion and spur gears.

3. Pushthegearstogetherwhiletighteningthemotorscrews.

4. Rotate the gears to remove the paper. The gearing should

move a small amount.

POWER

ST. TRIM

TH. TRIM

ST. RATE