Datasheet

Tel: [phone] Page 96
TOOLS FOR 516 SERIES CONTACTS AND CONNECTOR
Crimp Tools, Contact Insertion and Ejection Tools, Round Nut Driver
CONTACT CRIMP MACHINE
● Part Number 516-280-100
● Crimps Contact Part Number 516-290-591
● Guards and Microswitches for Operator Safety
● Easy Access for Quick Crimp Setting Changes
● Foot Switch Operation to Initiate Machine Cycle
● Cycle Speed Control (with Set-up Speed Option) on Circuit
Board
● Each Cycle Crimps Contact, Cuts the Contact Away from the
Carrier and Feeds a New Contact into Position
● Separate Crimp Settings for Conductor and Insulation
● Infinite Adjustment to Crimp Setting Between 18 and 28 AWG
● High Mechanical Advantage with Reliable Toggle Action for
Precise Crimp Dimensional Control, 1" (25.4) Die Stroke,
Effective Capacity 3 Tons (9.8 kN)
● Mounts with Bolts to any Bench Surface
● 80 psi (552 kPa) Minimum Air Supply and 117 V, 50/60 Hz
Electrical Supply Required, Step Down Voltage Tranformers
Available upon Request
CONTACT HAND CRIMP TOOL (1)
● Part Number 516-280-200
● Crimps Contact Part Number 516-290-590
● Precise Tool for Hand Crimping Loose Contacts
● Built-in Rachet to Prevent Under Crimping
CONTACT EJECTION TOOL (2)
● Part Number 516-280-300
● For Use with All 516 Series Contact Styles
● Provides Easy Positive Ejection without Damage to the Insulator
CRIMP CONTACT INSERTION TOOL (3)
● Part Number 516-280-400
● For Installing 516-290-590 & -591 Crimp Contacts
● Wire Groove Locates the Tool onto the End of the Crimp Form
POLARIZING HARDWARE ROUND NUT
DRIVER (4)
● Part Number 516-280-500
● For Removing and Tightening Round Nuts when Changing
Orientation of Metal Polarizing Guide Pins and Sockets
WIRE WRAP & P.C. TAIL CONTACT
INSERTION TOOL (5)
● Part Number 516-280-600
● For Installing 516-290-520, -540, -541 & -542 Contacts
● Slender Tube Protects Contact Tail during Insertion without
Interferring with Adjacent Contacts
➊➊
➊➊
➊
➍➍
➍➍
➍
➋➋
➋➋
➋
➌➌
➌➌
➌
➎➎
➎➎
➎