User's Manual

Acclarix AX3 Series Diagnostic Ultrasound System User Manual Measurements and Reports
- 68 -
Figure 8-2 Tool Options Touch Screen
Moving the measurement result window
The measurement result window is displayed on the top left corner of the image field by default, the
system supports changing the display position of the result window by dragging it.
To change the display position of result window:
1. Press <Cursor> hard key to invoke a cursor after a measurement is done.
2. Move the cursor over the result window, and press <Set> key, the result window will turn
green.
3. Move the trackball to locate a desired position within the image field for the result window.
4. Press <Set> key again to fix the result window on the new position.
8.1 Generic Measurements
A default generic measurement is automatically started when Measure is invoked. Each imaging
mode supports several types of measurements, as described below. You can switch between these
types using the touch screen buttons along the bottom of the touch screen. Some generic
measurements have options for the method used to perform the measurement. When the current
generic measurement has options available, you can view and change those options through the Tool
Options touch screen buttons.
Note:
The generic measurements supported in each imaging mode may vary with different exam presets.
The following sections describe all the generic measurements supported in each imaging mode.
8.1.1. B-mode Generic Measurements
The system supports the following types of generic B-mode measurements:
 Distance
 Circ/Area
 Angle
 Volume