User's Manual

SE-1010 PC ECG User Manual Operation Instructions for Exercise ECG
- 95 -
1. Select a display mode from the display mode pull-down list .
2. Select a gain from the gain pull-down list .
3. Select a speed from the speed pull-down list .
4. Select a lowpass filter from the lowpass filter pull-down list .
7.5 Pretest Phase
Click on Print to print the wave of 10 seconds before you click on Print.
Click on Keep, the system will keep staying in the current phase, and the current speed and slope
will also be kept until you click on Keep again.
Click on Next, the system will enter next phase/stage.
NOTE:
1. If the test time exceeds 40 minutes, the system will enter the monitoring status. Data
will not be saved, analyzed or printed any more.
2. The length of the pretest phase is not fixed, but it should be no less than 15 seconds.
3. The pretest phase report will be printed at the fourteenth second.
When the tracings are satisfying and you have specified the desired settings, you can start the
pretest.