User's Manual

SE-1515 PC ECG User Manual Introduction
- 21 -
Back Light
Select On to turn on the backlight of LCD screen.
Select Off to turn off the backlight of LCD screen.
Auto Sleep
Select On to display Sleeping on the screen and make DX12
transmitter be in low power consumption mode after lead off for 5
minutes.
Select Off to turn off auto sleep function.
Language
You can set the system language.
Lead Electrode
You can select IEC or AHA.
Match Device
Inquiring…will be displayed (for 10 seconds) to search DX12
receiver. The address of DX12 receiver will be displayed (for 8
seconds) if a matching DX12 receiver is found. No device found. Try
again later will be displayed (for 1 second) if no matching DX12
receiver is found.
Device
Information
You can see the related information, such as software version, ID,
address of DX12 receiver, manufacture and release time about the
device.
NOTE: The device information is for reference only.
2.3 Installing the Software
2.3.1 Requirements of the PC
CPU
Pentium P4, Celeron D 310 or above
System Memory (RAM)
1G or above
Main Board
Recommend the main board of Intel chipset
Hard Disk
128G or above
Printer
ink jet printer of more than 300dpi or laser printer
Recommend HP2035, HP2010, CANON iP1980
Display
17" TFT (Resolution: 1280*1024, 1366*768), 19" TFT
(resolution: 1440×900), 21" TFT(1920*1080)
Operating System
Windows XP SP3 (32 bit), Windows 7 SP1 (32/64 bit) or
Windows 8 (32/64 bit), Windows 8.1 (32/64 bit), Windows 10
(32/64 bit)