User's Manual
Acclarix LX3 Series Diagnostic Ultrasound System User Manual Troubleshooting and Maintenance
- 159 -
System Surface Cleaning
The validated cleaning agents for cleaning the system are:
Ethanol (75%)
Isopropanol (70%)
To clean the system surface:
1. Switch off the system and unplug it.
2. Wear sterile protective gloves to prevent infection.
3. Remove all residual foreign matters from the system surface using sterile cloth or paper towel
immediately after examination.
4. Use a sterile cloth dampened with cleaning agent to gently wipe the entire exterior surface,
including the screen, of the equipment thoroughly until no visible contaminants remain.
5. After cleaning, wipe off the cleaning agent with a sterile cloth dampened with tap water until no
visible cleaning agent remains.
6. Wipe off with a dry sterile cloth to remove residual moisture.
7. Leave the system to air dry.
8. If the system is not visually clean at the end of the cleaning steps, please repeat the cleaning
steps through step 4 to step 7.
9. Inspect the system to ensure that there is no damage.
NOTE:
1. Make sure the system is free of gel and any other visible residue.
2. Use a soft dry cloth without chemicals for cleaning. The monitor surface is easily scratched.
To clean the trackball:
1. Remove the front panel bezel.
2. Remove the trackball as shown in
Figure 13-1
.
3. Wipe the trackball, X and Y rollers, and the auxiliary idler wheel with a sterile cloth dampened with
the cleaning solution until no visible contaminants remain.
4. Wipe off the cleaning solution with a new sterile cloth dampened with tap water after cleaning until
no visible cleaning agent remains.
5. Wipe off with a dry sterile cloth to remove residual moisture.
6. Leave the trackball, X and Y rollers, and the auxiliary idler wheel to air dry.
7. Assemble the trackball and front panel bezel after the assembly parts completely dry.
Figure 13-1 Assembling and Disassembling Trackball
Rotate clockwise to remove
the fixing ring
Rotate counterclockwise
to mount the fixing ring