User's Manual

Acclarix LX9 Series Diagnostic Ultrasound System User Manual Imaging
- 61 -
Single, Dual,
Quad
These three radio buttons switch the display to show 1, 2, or
4 images at once. Single shows the 3D image, dual shows
the A slice and 3D image, Quad shows three MPR slices and
3D image.
VOI
Press to activate the function of adjusting VOI or clip plane.
Use the trackball to adjust and press <Set> to switch
between VOI and clip plane.
Cut
This is a folder of cut functions with various cut tools inside.
See below for details.
Cut tools
These are two radio buttons. The region inside or outside the
trace will be cut. To draw the trace, move the trackball and
press <Set> to locate the start point, use trackball to draw
trace and second press <Set> to locate the end point.
These are two radio buttons. The region inside or outside the
box will be cut. To draw the box, move the trackball and
press <Set> to locate the top left point, move the trackball
and a box is displayed. Press <Set> to locate the lower right
point of the box.
These two radio buttons switch the size of the eraser. To use
eraser to cut, move the trackball and press <Set> to locate
the first point, move the trackball and the path that the eraser
moves is cut, and then press <Set> to complete the cut.
Undo
Undo the previous cut operation
Redo
Redo the previous undo operation
Undo All
Return to the condition before cutting
Threshold
Adjust the threshold of surface render mode, Upward
presses increase threshold. Downward presses decrease
threshold.
Brightness
Adjust the brightness of 3D image