Manualshelf

User's Manual

ManualsBrandsEDAN INSTRUMENTS ManualsElectronicsElectrocardiograph
31323334353637383940
SE-301 Series Electrocardiograph User Manual Managing ECG Records
- 26 -
same as the last number of the IP of the DMS.
5. In the AUTO or RHYT mode, ECG data can be transmitted through the net automatically
after an ECG report is printed out.
Manual Transmission:
1. Choose Setup > Transmission to enter the Transmission Setup window.
2. Set Auto Transmission to Off and set Transmission mode to Ethernet.
3. For IP address setting, refer to step 3 and 4 for auto transmission.
4. To transmit all the data files to the PC, choose More > Trans All in the file management
window.
To transmit a single file, select it and click Trans.
NOTE: The transmission process is long, and please be patient to wait.
5.1.2 Transmitting ECG Records through WIFI Network (Optional)
If the WIFI module is configured, ECG records can also be transmitted through WIFI network.
WARNING
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received, including interference that may
cause undesired operation.
NOTE:
1. This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.