Product Manual

F6 and F6 Express Fetal & Maternal Monitor User Manual Installation Guide
- 13 -
2.3 Installing Monitor
The monitor can be placed on a flat surface, or be installed on a wall or a trolley. The service
engineer should install the monitor properly.
2.4 Connecting Power Cable
 Make sure the AC power supply of the monitor complies with the following specification:
100V-240V~, 50Hz/60Hz.
 Apply the power cable provided with the monitor. Plug one end of the power cable to the
power socket of the monitor. Connect the other end to a three-slot power output special for
hospital usage.
 The equipotential grounding terminal is provided for the connection of a potential
equalization conductor. Therefore, it is recommended to connect the grounding terminal of
the monitor and the power outlet with the grounding wire, making sure the monitor is
grounded.
WARNING
If the protective grounding (protective earth) system is doubtful, the power of the monitor
must be supplied by inner power only.
NOTE:
1 Make sure the monitor and the power outlet are placed at a place where it is easy to
connect and disconnect the power cord.
2 When the supply mains is interrupted, the device switches to inner power and
operates normally if the battery is installed. If the battery is not installed, the monitor
shuts down and resumes the previous settings at the subsequent operation.