Product Manual

Patient Monitor User Manual Installation
- 10 -
NOTE:
1 Check all the functions of the monitor and make sure that the monitor is in good
status.
2 If rechargeable batteries are provided, charge them after using the device every time,
to ensure the electric power is enough.
3 After long-time continuous running, please restart the monitor to ensure the monitor’s
steady performance and long lifespan.
2.5 Checking the Recorder
If your monitor is equipped with a recorder, open the recorder’s door to check if paper is properly
installed in the slot. If no paper exists, refer to Chapter Recording for details.
2.6 Setting Date and Time
To set the date and time:
1. Select Menu > Maintenance > User Maintain > Date/Time Setup.
2. Adjust the Date Format and Clock Format based on the user’s habit.
3. Set the correct time of year, month, day, hour, min and sec.
NOTE:
1 If the system is not used for a longer period of time, its system time may be
inaccurate. In this case, readjust the system time after powering on.
2 If the system time cannot be saved and resumes the default value after restart,
contact the service department of EDAN to replace the button cell in main board.
3 The default clock format is 24 hours. When Clock Format is set to 12 hours, please
select AM or PM according to actual situation.
2.7 Handing Over the Monitor
If you are handing over the monitor to the end-users directly after configuration, make sure that it
is in the monitoring mode.
The users must be adequately trained to use the monitor before monitoring a patient. To achieve
this, they should have access to, and read, the following documentation delivered with the
monitor:
 User Manual (this book) - for full operating instructions.
 Quick Reference Card - for quick reminders during use.
2.8 FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that