Product Manual

Patient Monitor User Manual Alarm Information
- 53 -
Message
Cause
Unable to Calibrate in Demo
Mode
Perform calibration in Demo Mode.
Calibrating...
Calibration is in progress.
C.O. Lack Param
Parameter is not configured for C.O. measurement.
Warm-up over
The monitor displays this message after taking the sensor
out of the bracket and warm-up is over.
Measure over
After the Predict measuring is over, the data and message
display on the interface.
Measure time out
No measuring result after the module entering Predict state
for 30 s.
Printer Busy
The monitor is performing a print job.
Recorder Setup Needed
The user presses the RECORD button or shortcut key
Record when Recorder is not configured.
No Default Printer
No default printer has been set.
Incomplete parameter input,
unable to score
In Warning-Score System interface, parameters are not
completely input.
No WIFI module detected
No Wi-Fi module is detected.
The space in U disk is less
than 300 M. Please clean it up.
The remaining space of U disk is less than 300 M.
Please input user password
first. Attention! Private
information included in the
data.
When user exports data from the internal storage device.
More than five consecutive
password errors
Continuously enter the wrong password for more than 5
times.
6.4 Adjustable Range of Alarm Limits
ECG alarm limits are listed as follows: unit (bpm)
Patient Type
Adjustable Range
HR
ADU
15~300
PED/ NEO
15~350
ST analysis alarm limits are listed as follows: unit (mV)
Adjustable Range
ST
-2.0~2.0