Specifications

6
DAX
E
Audio labs
Min
Max
LINE
(Re-AmpTube)
PEAK
HOLD
PEAK
HOLD
Vacuum Tube Microphone
Preamplifier
Vacuum Tube Microphone
Preamplifier
1
2
3
4
56
7
8
9
10
11
12
13
1) discrete input .
11)
12) Phase reverse switch,where
METER INSTRUMENT
PHASE:
GAIN Mic/Line:
PAD:
+48V:
An 11 position rotary switch that controls the gain of the stage
4) Selects between the MIC input (via the XLR input connectors on the rear panel) and Line
or DI input signals (via the rear Combo Neutrik 1/4" input jacks).
5) Supplies 48 volts to the XLR inputs for condenser microphones requiring phantom
power. Avoid selecting phantom power if you are using a dynamic, ribbon or tube mics.
2) The Red Led iluminate when the input level exceeds the maximum XLR input level
which is 3 dB below the overload point.
3) The Yellow Led iluminate when the phantom power is on.
6) The meter light indicates that the unit is on.
7) When the switch meter are in PPM mode allows
to freeze the meter needle at maximum peaks.
8) Allows select VU/PPM input and VU/PPM output modes.
Important:The meter is balanced connected direct to XLR IN/OUT connectors
and the measurement is in line levels Factory Cal:0dB Ref:+4dBu
9) An 11 position rotary switch that provides 12dB/octave low frequency rolloff with 11 user-
selectable turnover frequencies 20 to 250Hz.
10) Filter Switch
'+' is normal phase (input pin 2 hot), and '-' is inverted
phase (input pin 3 hot).
13) Output level control.
Ovl led:
Phantom led:
POWER:
PPM HOLD:
METER:
HPF:
HPH:
FRONT PANEL