E-C10-I-0209 Operator’s Instruction Manual EDCO CRACK CHASER Model C-10 RANDOM CRACK SAW 100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA Phone (301) 663-1600 • 1-800-638-3326 Fax (301) 663-1607 • 1-800-447-3326 Website: www.edcoinc.com Email: sales@edcoinc.
E-C10-I-0209 Equipment Instruction Manual EDCO C-10 CRACK CHASER READ AND UNDERSTAND THE OPERATORS INSTRUCTION MANUAL THOROUGHLY BEFORE ATTEMPTING TO OPERATE THIS EQUIPMENT. Death or serious injury could occur if this machine is used improperly. SAFETY MESSAGES SAFETY MESSAGES • Safety Instructions are proceeded by a graphic alert symbol of DANGER, WARNING, or CAUTION. Indicates an imminent hazard which, if not avoided, will result in death or serious injury.
E-C10-I-0209 Read and understand the Operator’s Instruction Manual, before operating this equipment. Death or serious injury can result if this machine is used improperly.
E-C10-I-0209 The C-10 is designed to rout out random cracks using the EDCO “laser welded” dry diamond blade. Width and diameter selection is critical to the operation of the unit. Edco offers a complete line of dry diamond blades for the C-10 including: Dia 8 8 8 x x x Blade Width .250 .375 .500 Slot Cutting Width Auger 3/8” 1/2” 5/8” Arbor 1” 1” 1” * “V” type blades are available. Call for further information. The blade turns clockwise when facing the shaft.
E-C10-I-0209 1/2” deep 1/2” deep 1/2” deep .250 width - Concrete - 10’ per minute .375 width - Concrete - 8’ - 10’ per minute .500 width - Concrete - 8’ - 10’ per minute When sawing is completed, lift blade out of cut using the blade raise/lower handle and allow engine to cool at idle for 2 - 3 minutes. MAINTENANCE The saw operates in very dusty conditions which require the special periodic maintenance actions noted below. Refer to the engine manufacturers manual for routine maintenance. 1.
E-C10-I-0209 E-C10-I-0209 SMI Dust and Silica Warning Repairs are to be preformed by EDCO or by approved EDCO repair technicians. Control dust, mist and fumes at the source where possible. In this regard use good work practices and follow the recommendations of the manufacturers/ suppliers, OSHA/NIOSH, and occupational and trade associations. Water should be used for dust suppression when wet grinding/cutting/drilling is feasible.
E-C10-I-0209 LIMITED EQUIPMENT WARRANTY OF SALE – TERMS & CONDITIONS Equipment Development Company, Inc. herein referred to as EDCO (Seller) warrants that each new unit manufactured by EDCO to be free from defects in material and workmanship in normal use and service for a period of (1) one year (except for the cutter drum assembly on all model concrete/asphalt planes, in which case the warranty period shall be 90 days) from date of shipment to the original retail or equipment rental center owner.