OWNER’S MANUAL 21", 24", 27" BURNISHER Powered by the EPA/Carb Certified Kawasaki 603cc Engine Available With Optional Dust Control Upgrade CE, LEED, CARB, EPA & GS-42 COMPLIANT
PG. 2 IMPORTANT SAFETY INSTRUCTIONS Read and observe all DANGER, WARNING, AND CAUTION statements included in the Owner’s Manual and affixed to the machine. These statements indicate that there is a possibility of death, bodily injury, and damage to the machine or property if these instructions are ignored. Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this machine.
PG. 3 Keep all objects clear of the exhaust system during and after operation. Do not leave this machine unattended while the engine is running. Do not operate equipment in one location for more than a few seconds. Damage to floor surface can occur. Always store equipment away from possible damage by falling objects in warehouse-type areas. Always store LPG tanks outside in a secure, well-ventilated area. The muffler and engine become hot enough during operation to cause severe burns.
PG. 4 ! CAUTION Do not use “T” handle when attempting to tilt back machine for service or cleaning. The “T” handle is designed for control during operation only. Do not use excessive vertical pressure. I. PREPARATION A. Check that the suggested maintenance schedule has been observed: D. Connecting the high pressure hose to the LPG Tank: Make sure the couplers are in line and screwed together hand tight. If this is not done properly, fuel will not pass through to the regulator.
PG. 5 III. OPERATION Provide and use ear protection during operation. Never let an untrained person operate or perform repairs on the machine. They may hurt themselves, damage the floor or the equipment. Engine speed not to exceed 3400 RPM. This machine is not suitable for picking up hazardous dust. Do not use on surfaces with a gradient exceeding 2%. IV. STOPPING THE ENGINE Turn the propane tank valve clockwise to a closed position and turn the key OFF.
PG. 6 b. Charge the battery or provide an absolute source of 12 volt DC power capable of 50 amperes total output. (A pair of good jumper cables from your car or truck battery will suffice.) Equip yourself with an inexpensive 12 volt test light. c. If the trouble seems to be in the electrical control equipment, you may wish to disconnect the starter from the system so as to check the system without spinning the engine. d. Battery rundown. A common problem is letting the battery run down.
PG. 7 Engine Oil Capacity FS481 1.5 L (1.6 US qt.) when oil filter is not removed 1.7 L (1.8 US qt.) when oil filter is removed 1.7 L (1.8 US qt.) when oil filter is removed ! CAUTION! Before removing the oil filter, place a suitable pan under filter connection. • Drain engine oil into a suitable container. Oil Change Change oil after first 8 hours of operation. Thereafter change oil every 50 hours. • Run the engine to warm oil. • Be sure the engine (equipment) is level. • Stop the engine.
PG. 8 KAWASAKI ENGINE MAINTENANCE SCHEDULE INTERVAL MAINTENANCE Daily Check and add engine oil Check for loose or lost nuts and screws Check for fuel and oil leakage Check battery electrolyte level Check or clean air intake screen • • • • • First 8 hr. Every 25 Hr. Every 50 hr. Every 100 hr. Every 200 hr.
PG.
PG. 10 Quick Start Guide 1. Read, understand and observe all Important Safety Instructions before operating the machine (See Pg. 2). 5. Set the throttle lever position. 2. Make sure the machine is properly maintained prior to use (See Pg. 2 & 10). 3. Make sure the LPG tank A is filled, connected and checked for leaks. (See Pg. 2 & 3). 6. Turn key D to start [ | ] position. 7. Move throttle lever C toward run position. If motor fails to start, return to Step 5 above. C A B to idle 8.
PG.
PG.
PG.
PG. 14 KAWASAKI 603cc ENGINE PART # 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. DESCRIPTION Foam Hat Filter Debris Screen Foam Hat Seal Oil Pressure Switch Oil Filter Oil Drain Valve 1 / 4 x 1 1 / 4 Key Crank Pulley Exhaust Manifold Gasket Exhaust Manifold Catalytic Muffler Air Filter Element Foam Pre Filter PART # 186-271964 309-18540-603 175-8.25*9.
PG.
WARRANTY This Burnisher is warranted to be free from defects in material and workmanship for a period of one year from the date of sale. All engines are warranted by the manufacturers (Kawasaki) for a period of two years when engine maintenance schedules are followed. The warranty does not apply to damage or failure caused by abuse, misuse, neglect, disassembly, alteration, unauthorized modification or repair, lack of proper maintenance, theft or damage by freight carriers.